Why is the pilot light on my Rheem water heater not working?
If the pilot light on your Rheem water heater won’t light or stay lit, it could be because of a blocked gas line. Other possible causes for this problem are a faulty thermocouple, malfunctioned gas valve, or something as minor as draft coming from a crack in the wall or under the door.
What is the fault code on a Rheem water heater?
Rheem water heater blinking light codes There are fault codes that can be shown through the amount of blinking lights on the Rheem heat pump controller. The blinking light codes vary depending on the unit, either 310L or 325L.
How do you turn off a Rheem water heater?
Rotate the gas knob on your Rheem water-heater clockwise until it is in the “Off” position. Rotate the water-heater temperature dial counterclockwise until it is set to the lowest temperature setting. Wait five minutes to allow any gas in the water-heater to pass through. Lift the outer door off of your Rheem water-heater.
How do you change the pilot light on a water heater?
You can see the pilot light through the viewing window on the water-heater’s inner door. Continue to hold down the red button for one minute after the pilot is lit, and then release it. The pilot will remain lit. Replace your water-heater’s outer door. Rotate the gas knob counterclockwise until it reads “On.”
What are some common problems with a Rheem water heater?
Rheem Water Heaters – Common Issues No Hot Water. A tripped circuit breaker will shut down an electric heater and gas models that use electricity. Not Enough Hot Water. If the water heater is new, or if you’ve just moved into a new home and aren’t familiar with the water heater’s capability, it’s likely that There’s Water on the Floor.
How does a pilot light go out on a water heater?
Some of the most common reasons that water heater pilot lights go out include: A faulty thermocouple. Your thermocouple is responsible for sensing when your pilot light is lit. If it senses that the pilot light has gone out, the thermocouple shuts off the gas supply to the flame in order…
How do you light the water heater pilot?
Turn the gas knob to “Pilot,” press and hold it down. This will start the flow of gas so you can light the flame. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold.
Why is the water heater pilot light keeps going out?
There are several things that can cause your gas water heater pilot light to keep going out. One of the most common is your thermocouple. If you are unfamiliar with what this device does, the thermocouple is a device in your hot water heater that uses an electrical current to determine whether the pilot light is on or not.
