Why is my washing machine start button blinking?
OK so this just means the washer doesn’t think the door is shut. Try to unplug the washer for 5 minutes and see if the electronics will reset. Shut the door firmly and try to start it again. You’ll need to unplug the washer and open the door to start with.
What does a flashing wash light mean?
The Wash Light is On or Flashing when the water level does not change for a period of time OR water is present but the control does not detect the water level changing.
Why does my washing machine pause?
During the rinse cycle, the water inlet valve opens to allow water to enter the wash tub. If the water inlet valve fails, the washer will continue waiting for the water to enter the washer, causing it to stop mid-cycle. To determine if the water inlet valve is defective, use a multimeter to test it for continuity.
Why is my Cabrio washer power light blinking?
The issue is that the lid switch is not making contact and may even be shorted out. The blue light flashing is the same message that would be displayed if the lid was opened during a cycle. There is a one year warranty so it should be covered. Try leaving it unplugged for an hour or so.
Which is the start button Flash but not the pause button?
Press and hold start and skip together. While holding them, switch on. The lights will flash. Release the buttons and the lights should scroll. Press and release the fabric button repeatedly until you get the 2nd bottom led of the 2nd column lit. Look at the column of 8 leds on the right. Number them with 1 at the top. Which numbers flash?
Why does my ge washer light keep blinking?
When the drive motor is operating normally and running, the inverter control LED blinks at a constant rate of 1/2 second on and 1/2 second off. When the drive motor is operating normally, and idle, the LED blinks at a constant rate of 1 second on and 1 second off.
How can I get the light off my ge washer?
Pull up on the top slightly on the left side and use the putty knife in the same way on the right side to release the clip on that side. Pull up the top, then flip it back and lean it against the wall. Unscrew the screws on the top of the front panel using a Phillips screwdriver.
What does an error code mean on a GE washer?
The drive motor doesn’t run and an error code is signaled when a component problem is detected. Error codes are signaled by a number of LED flashes followed by a pause. The error code repeats continuously until reset.
Why does my washing machine pause after a cycle?
The pause can occur because of the following: A power failure or if it was put in the test mode at the factory. If the washer was stopped before the cycle was complete. The stop/pause button was pressed to temporarily stop the cycle and was not reset. In this case, the washer will pump out and spin after 24 hours, but will stay in the final spin.
When the drive motor is operating normally and running, the inverter control LED blinks at a constant rate of 1/2 second on and 1/2 second off. When the drive motor is operating normally, and idle, the LED blinks at a constant rate of 1 second on and 1 second off.
Why is my washer not resetting the controls?
If there is a pause in the washer cycle, the controls will lock up. The pause can occur because of the following: A power failure or if it was put in the test mode at the factory. If the washer was stopped before the cycle was complete. The stop/pause button was pressed to temporarily stop the cycle and was not reset.
What should I do if my washing machine wont turn on?
To correct the situation, shut off the circuit breaker for 30 seconds or unplug the washer, then turn the timer knob around and back to any position other than final spin. Verify the water is turned on and restore power. This should resolve the issue.
