Why is my irrigation system pulsating?
There can be two problems with the nozzle. It can be clogged and not send a solid stream of water, or it can be leaking. Both of these problems can be caused by dirt or other debris. Drop the nozzle into a bucket of warm soapy water and let it set there.
Why do I need small GPM zones in my irrigation system?
Most irrigation systems have areas that need small GPM zones. Overlapping these areas with other zones doesn’t always work. Also if you ever use a garden hose, it throws the irrigation design out the window. Small zones and garden hoses will cause the pump to cycle itself to death.
Why is one zone of my sprinkler system not working?
Each zone consists of several sprinkler heads controlled by a valve that is electrically activated. If a single zone is not working, the problem is usually an electrical issue or a defective …
Why does my irrigation pump turn on and off?
After priming it, I turned the system on and immediately noticed a clicking sound which the pump would turn on and off by itself; not good for the pump, so I cut the power and decided to troubleshoot.
Can a CSV pump be used as an irrigation system?
Some irrigators see the CSV as a Band Aid for a bad irrigation design. Others use the CSV as a way to design the perfect irrigation system. The CSV will work with even a very small pressure tank, and allows you to use any size zone down to 1 GPM, or a garden hose, without cycling the pump.
Each zone consists of several sprinkler heads controlled by a valve that is electrically activated. If a single zone is not working, the problem is usually an electrical issue or a defective
After priming it, I turned the system on and immediately noticed a clicking sound which the pump would turn on and off by itself; not good for the pump, so I cut the power and decided to troubleshoot.
What to do when your sprinkler system is low?
A sprinkler system won’t operate as supposed to when the water pressure is low, which will result in dead patches of lawn. To increase the pressure, detach a few sprinklers from each zone and close the pipes. Then, install a booster pump on the main water line.
How does a pump relay work in an irrigation system?
Pump Relay Some irrigation systems have the option of drawing water directly from a well, tank, creek or pond, rather than using a municipal source. In these situations, the water must be pumped through the system using a pump relay each time the control box turns on a valve.
