Why does my Riello oil burner not turn on?

There is oil entering the fuel pump but when the pump turns no oil exits. After bleeding the pump, still no oil exits. So I removed the pump, checked the flexible coupling which is fine, so am certain that the pump is rotating. With the cover plate removed and manually turning the pump, the residual oil seems to move around.

Where can I find the Riello burner manual?

RIELLO BURNERSYSTEM MANUAL Compliments of Aspen Gas & Oil Services Ltd Page 6 of 12 1-250-489-3780 866 802 3641 OIL LINE CONNECTIONS (see figure 10) The burner is shipped with the pump set up for a two pipe system; 2 pipe connectors, 3, are supplied with the burner for connection to either a single or two pipe system.

What’s the pump psi on a Riello burner?

Pump is factory preset at 146 PSI (10 bar). 1a) LIFT (2 pipe) SYSTEM – The burner is shipped for installation in a two pipe system. See Table A for pipe lengths. Be sure that there are no air leaks or blockages in the piping system.

What do you need to know about the Riello 40?

PRIMARY CONTROL SUB-BASE 8. WIRE HARNESS FOR AIR SHUTTER 3. FUEL UNIT (PUMP) 9. COMBUSTION HEAD WITH DRAWER ASSY. 4. PSC MOTOR 10. SEMI FLANGE 2 PIECES 5. CAPACITOR 11. UNIVERSAL MOUNTING FLANGE & GASKET 6. AIR ADJUSTMENT AND SHUTTER 12. AIR TUBE COVER PLATE 13 PUMP VALVE (COIL)

What are the components of a Riello 40 F5 burner?

STANDARD RIELLO OIL BURNER MODELS 40 F3 & 40 F5 BURNER KEY COMPONENTS 1. 530 SE/C INTEGRATED PRIMARY CONTROL 7. ELECTRONIC AIR SHUTTER ASSY. 2. PRIMARY CONTROL SUB-BASE 8. WIRE HARNESS FOR AIR SHUTTER 3. FUEL UNIT (PUMP) 9. COMBUSTION HEAD WITH DRAWER ASSY. 4. PSC MOTOR 10. SEMI FLANGE 2 PIECES 5. CAPACITOR 11.

Why does the Riello 40 F5 noisy pump work?

As far as the motor goes it operates whenever the burner comes on for the whole cycle because there is a coupling connected from the motor to the pump which is how the oil is delivered. If you feel brave you can remove the motor and try running it without a load to see how it reacts.