Why does my gas stove pilot light keep going out?
Sometimes pilot lights go out because the flame is set too low. The owner’s manual provides information for adjusting the flame. Other problems like low gas pressure, a loose or faulty thermocouple or a gas control valve that’s not working right can also cause the pilot light to keep going out.
How to troubleshoot pilot light in gas water heater?
When troubleshooting lighting problems, it is recommended to test it first. Turn the gas OFF to the water heater and press the piezo igniter. Once pressed, the electrode should release the spark. Check if the wire connection is tightened correctly. Make sure the electrode is not broken, and replace it if it is.
What should I do if my pilot light is not working?
Check if the wire connection is tightened correctly. Make sure the electrode is not broken, and replace it if it is. Soot and/or carbon deposits on the pilot light. Clean the tip of the electrode from the dirt, rust, and other deposits by using the dry cloth and sandpaper.
What does a yellow pilot light mean on a gas heater?
A typical and healthy pilot should burn with a bright blue luminosity, not a yellow or red. A yellow flame means that there is no sufficient air flow, that the gas combustion is not complete or the pilot tube is dirty. A flickering or wavering flame is an indication of the draft.
What should the pilot flame be on a propane tank?
Important: Before troubleshooting the pilot light, keep in mind that a pilot flame is always ON and the flame should be blue. If it is yellow, it needs an adjustment. Make sure that the tank is completely filled with water before lighting the pilot light.
When troubleshooting lighting problems, it is recommended to test it first. Turn the gas OFF to the water heater and press the piezo igniter. Once pressed, the electrode should release the spark. Check if the wire connection is tightened correctly. Make sure the electrode is not broken, and replace it if it is.
How much gas does a pilot light burn?
burn gas based on the size of orifice and the BTU content of the gas. An example is an .018 size natural gas orifice on a pilot at 7 inches water column pressure will burn 1.12 Cubic Feet per hour of gas. That make that pilot at around 1,000 BTU’s per hour which is pretty typical.
How many CF / Mo does a pilot light use?
How we cope without heat (in San Diego, granted) is a story for another time. In my current house, as indicated in the photos and associated numbers above, the hot water heater’s pilot light consumes about 0.44 cf/hr, or 3.3 Therm/mo. This is pretty comparable to the old condo’s hot water heater, so is probably pretty typical.
A typical and healthy pilot should burn with a bright blue luminosity, not a yellow or red. A yellow flame means that there is no sufficient air flow, that the gas combustion is not complete or the pilot tube is dirty. A flickering or wavering flame is an indication of the draft.
