Why does my Delta 1300 faucet not shut off?

This answer was rated: replaced cartridge on Delta 1300/1400 faucet and still wont… replaced cartridge on Delta 1300/1400… replaced cartridge on Delta 1300/1400 faucet and still won’t shut off completely. Cartridge is brand new, bought last night at Lowes.

How do you get a valve out of a Delta Faucet?

Do not pry the valve cartridge out of the body with a screwdriver. Place the handle on the cartridge stem and rotate it counterclockwise approximately 1/4 turn after the stop has been contacted. Remove the handle. Grasp the brass stem in the center of the white plastic assembly and pull it directly out, away from the wall.

Where do you put a thermometer in a Delta Faucet?

Place a thermometer in a plastic tumbler, and hold the tumbler in the water stream. Counterclockwise if you have a Monitor® 1300 or 1400 series model (handle controls the temperature only, not the volume).

Where is Phillips head screw on Delta Faucet?

A clear knobs will have a Phillips head screw located just under the plastic cap; a lever handle usually has a small set screw located on the side. Slide off the finished metal (chrome, polished brass, white or almond) sleeve that covers the valve.

What kind of faucet cartridge does Delta monitor use?

The Delta RP19804 faucet cartridge was designed for the Delta monitor 1300 and 1400 series tub, shower and tub shower bath faucets. Anyone can install a new cartridge, or repair their old cartridge for a fraction of the cost.

How do you repair a delta water faucet?

Install new genuine Delta metal seats and rubber springs into the lower section of the faucet cartridge. Reconnect the lower and upper sections of the cartridge. Reinstall the whole cartridge back into the faucet body. Install the retaining nut trim sleeve and faucet handle. Turn the water on and inspect the faucet for leaks and drips.

Can a Delta monitor shower cartridge be repaired?

Install a new cartridge, or repair your Delta RP19804 and save a bundle. Delta Faucet has designed one of the few single-handle tub and shower faucet cartridges that can be repaired. The Delta RP19804 faucet cartridge was designed for the Delta monitor 1300 and 1400 series tub, shower and tub shower bath faucets.

Why is my Delta shower valve not working?

Without hot and cold pressure these valves won’t allow any water past. Bad cartridge or you have the temperature adjusted to full hot…check the temp setting on the stop wheel. Which valve is this? 1400 series, 1700 series? You can adjust full hot temp but that won’t disallow cold water.

What are the controls on a Delta shower?

The stem actually has two controls. The end of the stem (that which I could grab with my channel locks) controls temp. Then further down the cartridge is a control wheel that looks like a gear around the stem. You have to use the big handle for that and that controls the on and off.

What to do if your delta 1400 series Monitor is not working?

If you are not sure where your home’s shut-off valve is located, you can call your water company and ask them to temporarily turn off your water while you repair your Delta faucet. Open the Delta faucet and all the outside faucets around your home to drain any remaining water pressure from the plumbing system.

How do you install a Delta monitor in a new faucet?

Install a new Delta 1400 series Monitor pressure-balance faucet cartridge into the manifold. Make sure to line up the hot side of the cartridge to the left side of the faucet body. There are markings on the top of the faucet cartridge indicating which side of the cartridge is for hot water.