Why did my oil filter housing break off?
After further inspection, one of the tabs broke off of the plastic-ass oil filter housing, exposing the inside of the housing to the world. 1.) The dealership put the housing on way too tight. 2.) The plastic housing is a piece of garbage. 3.)
How to change the cartridge oil filter housing?
I’ve been doing cartridge oil filter changes on Toyota engines since 2004. I’ve never damaged any plastic housing. Toy640 housing wrench. Regular filter cap wrenches that almost fit aren’t good. You risk damaging the housing. Secondly….and very importantly….the housing is sealed via an o-ring not a gasket.
What to do when your water filter goes off?
The second handle after your water filter you’ll want to turn off. This prevents a back flow of water in the line from coming back to you when you open the filter housing. The third handle is the bypass handle that should have been off (ie it was forcing the water to go through your water filter). You’ll now want to open this handle.
Why does my water filter keep blowing off?
It can also be the reason for a cracked tank or even more dramatic, the filter lid blowing off. As mentioned above, high filter pressure is a problem but so is low pressure which usually indicates some obstruction of the water going into the filter.
What causes a hot tub filter to get stuck?
A lot of times a stuck hot tub filter is caused by the hot tub owner not installing the filter correctly or not using the hot tub filter properly. You should only hand tighten your hot tub filter never use a tool to tighten the filter. Using a tool may damage the housing or make it difficult to remove.
What’s the best way to remove a hot tub filter?
Once you have turned the power off the best tool to help you turn the filter is a strap wrench it will allow you to have the best leverage to remove the hot tub filter. You may have to remove the water to give yourself better access into the hot tub filter area.
How to get a stuck water filter out?
Hold the plastic ring around the water line down then pull the line out. The second image will give you a visual on removing the water lines. Then inspect the end of the water lines. If they are smooth, insert them into the new housing.
How does the handle on a water filter work?
The valves are usually usually simple handles that turn 90 degrees. When the handle is flush with the pipe water is allowed to flow. When the handle is 90 degrees from the pipe it is shut off. Some systems use flower stem handles in which case righty tighty is closed and lefty loosey is open.
