Which is the best type of Lowara pump?
The Lowara e-SH series is a single impeller centrifugal pump made in AISI 316 stainless steel making it the right pump for moving water and aggressive liquids… e-SV vertical multistage pump in stainless steel The Lowara e-SV vertical multistage pump is a highly reliable and technologically advanced multipurpose pump….
How to install a domino up pump control panel?
Call us on 01777 871100 for support if needed. Domino Up electronic control panels for centrifugal pumps, with dry running protection via cos-φ and minimum current. Offering total pump control and protection. Easy to install and very simple to operate with a full LCD display.
What should I do if my water pump stops working?
The majority of pumps have dry run protection, which cuts in to protect them from damage if the water supply is interrupted. If this protection kicks in, the pump will stop. You need to turn off the mains power to the pump for a few seconds to reset the pump (there will usually be an isolator switch or fused spur).
Why is my central heating pump setting too low?
If the hot water is only reaching some of the radiators in the system, then it’s likely that your pump pressure setting is set too low. There is also a chance that it could be debris in the system that is slowing down the flow of the water. First, try adjusting the pump pressure dial.
The Lowara e-SH series is a single impeller centrifugal pump made in AISI 316 stainless steel making it the right pump for moving water and aggressive liquids… e-SV vertical multistage pump in stainless steel The Lowara e-SV vertical multistage pump is a highly reliable and technologically advanced multipurpose pump….
Call us on 01777 871100 for support if needed. Domino Up electronic control panels for centrifugal pumps, with dry running protection via cos-φ and minimum current. Offering total pump control and protection. Easy to install and very simple to operate with a full LCD display.
Why is there no pressure on my shower pump?
In hard water areas it could have become clogged with limescale, or the problem could be due to a fault like a broken impeller. Unfortunately, in either of the scenarios listed above, this is probably a sign that you’ll need to replace the pump. The most common symptom of an issue with your shower pump is the lack of pressure in your shower.
The majority of pumps have dry run protection, which cuts in to protect them from damage if the water supply is interrupted. If this protection kicks in, the pump will stop. You need to turn off the mains power to the pump for a few seconds to reset the pump (there will usually be an isolator switch or fused spur).
