Which is the best type of irrigation pump?
The two most widely used are horizontal centrifugal and vertical multistage. The selection of the pump depends on three factors: how much pressure is required to run the system, what type of efficiency must be reached, and the type of water—municipal, reclaimed water or gravity supply tanks.
When do you need a booster pump for an irrigation system?
A booster pump may be required when pushing water from above ground, municipal or a reclaimed water source if the primary pump does not provide enough pressure. Primarily, booster pumps are used on domestic or municipal water systems when the existing pressure is not adequate for the irrigation system.
Why do you need a screen for an irrigation pump?
The screen is important because without it, the irrigation system can get plugged up. Submersibles and vertical multistage pumps are recommended for boosting clean water. Solids or debris can damage these without the use of components such as filters.
What to consider when designing an irrigation system?
The design of an irrigation system, as well as the site characteristics, can have dramatic ramifications for the cost of the pump. If an irrigation system designer is not familiar with pumps, they may specify pipe sizing, pump location or watering time requirements that dictate certain pump styles to achieve the required performance.
Where is the best place to install an irrigation pump?
It’s much easier for a pump to push water out than it is for it to pull water upward, so it’s best to install your irrigation pump as close to the water source as possible without risking water-damage to the pump.
How tall does an irrigation pump have to be?
Irrigation pumps aren’t capable of sucking water beyond 25 feet above their water source. If you have to locate your pump higher above the water source, consider a different type of pump.
A booster pump may be required when pushing water from above ground, municipal or a reclaimed water source if the primary pump does not provide enough pressure. Primarily, booster pumps are used on domestic or municipal water systems when the existing pressure is not adequate for the irrigation system.
What are the different types of irrigation pumps?
There are two main actions that a pump performs in an irrigation application: pressure boost or suction lift. The four styles of pumps that are typically used for these applications are horizontal centrifugal, submersible, vertical turbines and vertical multistage pumps. Each style lends itself to some applications better than others.
