Where to find the serial number on a triangle tube?

Where to find the serial number on a triangle tube?

Here are a few tips on how to find the serial number on your Triangle Tube product. Where can I find the serial number on a PA unit? To find the serial number on a Prestige PA boiler, please look towards the bottom of the right side panel of the unit. The serial number will be PA, PB or PEA followed by 6 digits (e.g. PA123456, PEA123456, PB234567).

What do you need to know about triangle tube heat exchanger?

Ensure the boiler and heating system have been properly purged and there is no air trapped in the top of the heat exchanger. Inspect and verify heating system piping and its components.

When to contact triangle tube for technical support?

If problem is not resolved, contact Triangle Tube Technical Support for additional assistance. Check to see if a sensor is far out of calibration or moving in a direction un-compatible with the process that the controller is presently running. With the unit off for at least 1 hour, go to the Info mode of the boiler. Look at steps 1, 2 and 5.

How many ohms does a triangle tube gas valve have?

The gas valve should have a 32 ohm reading on coil 1 and 18 ohms on the second coil. The rectifier head on the gas valve may also be shorted, requiring all three parts (gas valve, rectifier head, and MCBA) to be replaced.

How long does it take to install a triangle tube?

• When receiving the SMART unit, any claims for damage or shortage in shipment must be filed immediately against the transportation company by the consignee. • Customer must register unit within sixty (60) days of installation in order to gain warranty coverage. See Warranty Card for details.

What do you need to know about triangle tube?

• Faulty parts must only be replaced by genuine Triangle Tube factory parts. • To prevent damage to the inner tank, the Installer must: – Always fill inner tank prior to outer tank and always drain outer tank prior to inner tank. – Relieve primary system pressure below 15 psig prior to draining inner tank.

Who is responsible for damage to triangle tube?

Triangle Tube accepts no liability for any damage, injury, or loss of life resulting from incorrect installation, alteration of any factory supplied parts, or the use of parts or fittings not specified by Triangle Tube.

You Might Also Like