Where should bath taps be placed?

Where to position a shower or bath tap

Bath taps can be installed in three ways; on the bath tub, on the floor or on the wall. On the tub itself.
On the wall.
On the floor. This type of installation is only needed with island tubs.

Are bath taps standard width apart?

I am replacing standard taps with a Mixer tap. However their is a standard width between the pipes for most new Mixer taps 180mm.

How high should bath taps be?

Generally, a shower head situated at around 2000mm is a good height suitable for most people with the taps around 1000mm to 1200mm from the floor. Positioning the taps away from the shower head will allow you to turn the water on without getting wet while you wait for the water to warm up.

How high should wall mounted bath taps be?

roughly eight to ten inches
How high a mounted tap should be depends on the style and shape of the tap but these are the recommendations: For wall mounted basin taps it is recommended that the wall mounted tap is situated roughly eight to ten inches above the sink in order to comfortably wash your hands without knocking the basin.

How high above Bath should taps be?

Everyone loves a hot bubble bath! Tapware should be situated approximately 100mm to 150mm above the top of the rim.

Can you change taps yourself?

This is a job you can do yourself, but just how do you fit new taps? This is one of those tasks which shouldn’t be too difficult or too expensive. Fitting new bathroom taps should be a straightforward enough project to take on yourself, so long as you use common sense and follow simple instructions.

What’s the best way to fit a bath tap?

Start by laying down a strip of masking tape along the tap end of your bath. Step 2. With the help of a tape measure, mark the centre of the overflow and using this as a guide, measure the position of the tap holes. If you’re using a bath mixer tap, use the width as your guide for fitting. Step 3.

Is it bad to fit bath taps against side wall?

with great skill fella. Fitting bath taps against the side wall is always a BAD idea. But if you must make up a long copper or speedfit tail and fit it to the taps before fitting the bath. Best advice though – don’t do it…you will regret it one day.

What kind of tap is used in a shower?

Mixer taps—1 tap which combines both hot and cold water. These sometimes include a shower fixture too, known as a bath shower mixer tap. There are other, less common bath tap options available, including freestanding taps, wall mounted taps and valve-operated bath fillers. If you’re unsure which tap you have, check out our bath tap buying guide.

How to replace hot and cold bath taps?

You can use a flathead screwdriver to turn off your hot and cold tap at the compression fitting – if you do not have compression fittings then switch your water off from your mains water supply. Step 2. Remove Your Old Tap Next you must remove your old tap.

What’s the best way to fit bath taps?

Move the bath away from the wall and attach the wall fixing brackets to the side of the bath. It’s now time to fit the bath taps. Check out our “ how to fit bath taps” guide for instructions. Secure the bath waste in place using the washers provided. A thin bead of silicone can help keep the seal watertight for longer.

How to install a bath shower mixer tap?

This video shows you how to install a bath shower mixer tap. Bath shower mixer taps are normally installed on your bath and incorporate the bath taps and shower head, with a diverter to choose between the two outputs.