Where is the water inlet valve on Asko dishwasher?
The water line inlet valve is on the right rear of the machine.
Why is my Asko dishwasher not starting?
If the thermal fuse blows, it will prevent the dishwasher from starting. To determine if the thermal fuse is defective, use a multimeter to test the fuse for continuity. If the thermal fuse does not have continuity, replace it.
How do I unlock my Asko dishwasher?
To open the door, you must press the white plastic catch (illustrated below) to the left while pressing the door latch up. Reset by turning the screw slot back to a horizontal position. You can activate the child lock (button lock) to prevent children from starting the dishwasher (see the section Settings).
Is there a limited warranty on Asko Appliances?
YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR AS PROVIDED HEREIN. This Limited Warranty is valid only when the ASKO Product is used in the country in which it was purchased. Proof of original purchase date is required to obtain service under this Limited Warranty.
How is a dishwasher connected to a sink?
The dishwasher is fitted with an integrated anti-siphon device to prevent the machine from being emptied of water during the wash cycle. ÅÁÆ ¾¯¿vv Ð ÀÄÀ¯Åvv The drain hose can also be connected to a connection nipple on the sink unit’s water trap. The connection nipple must have an internal diameter of at least 1/2”.
How to put a dishwasher on the counter?
Use a flat head screwdriver or a socket screwdriver. 4 Adjust the front feet by turning them clockwise to raise and counterclockwise to lower the dishwasher. 2x ¾vv ¯Åvv 5 Verify there is an air gap of at least 1/8” between the underside of the countertop and the top edge of the dishwasher. 6 Slide the dishwasher into place.
What should I do before installing a dishwasher?
• Place a drip tray on the floor beneath the dishwasher to prevent damage from any water leaks. • Before screwing the dishwasher into place, test the dishwasher by running the Rinse and hold program. Check that the dishwasher fills with water and drains. Also check that none of the connections leak.
How to use and care for ASKO d3530 dishwasher?
Proceed as follows: 1. Switch off the machine at the main switch. 2. Hold in the Set button while pressing the main switch 3. Parts of the dishwasher* 1. Knife basket 2. Upper basket 3. Lamp 4. Spray arms 5. Lower basket 6. Cutlery basket 7. Rinse Aid Filling 8.
Where can I find the owner’s manual for Asko Appliances?
Installation instructions and the owner’s manual. You can search by using model name (example DFI664XXL) or article number (example 728608).
What kind of salt does Asko dishwasher use?
Page 4 Rinse aid Pour in rinse aid Select dosage Salt Pour in salt Fault indications Troubleshooting The dishes are not clean Stains or a film on the china The china has a whitish-blue sticky film Stains on stainless steel or silver Stains which remain after dishwashing.
Why are there rules when installing a dishwasher?
There are lots of rules you need to be aware of when installing a dishwasher for the first time. Because dishwashers use both water and electricity, the risk of a catastrophic outcome should something go wrong is much higher than for most other appliances – the rules exist to keep you, your home and everyone else safe.
