Where is the thermostat located in Kenmore refrigerator

On most Kenmore models, the thermostat is on the back of the unit for side-by-side devices and at the bottom of the fridge for the over-under units. Remove the panel covering the thermostat. You may need to use a screwdriver in order to do so. Then, check the coils of the thermostat.

Where is refrigerator thermostat located?

Locate the thermostat using the owner’s manual for your refrigerator. For side-by-side refrigerator/freezers, the thermostat is often on the back of the unit, whereas for over/under units, the thermostat is more likely to be under the fridge.

How do I know if the thermostat has gone in my fridge?

The Refrigerator Is Not Cool Enough.
Unusually Cold Refrigerator.
Refrigerator Temperature Fluctuation.
Sub-Zero Refrigerator Temperature Troubleshooting Tips.
Contact Wilshire Refrigeration.

Where is the defrost thermostat located on a Kenmore refrigerator?

The defrost thermostat is located behind the back panel of your side-by-side refrigerator/freezer. You will first need to remove the panel and take the defrost thermostat out to complete the repair.

How do I reset the temperature on my Kenmore refrigerator?

To adjust the temperature of a Kenmore refrigerator, select the fridge temp and freezer temp buttons. Hold these for a few seconds until the display beeps. Press the fridge temp button and go through the available temperatures until you find the 37 degrees Fahrenheit setting.

Where is the freezer thermostat located?

In freezer-on-top models, it may be located under the floor of the unit, or it could be found at the back of the freezer. If you have a side-by-side refrigerator, the defrost thermostat is found at the back of the freezer side.

What are the symptoms of a bad thermostat?

Overheating Engine. If the thermostat stays closed, the engine’s coolant cannot reach the radiator and, therefore, cannot cool down. …
Temperature Fluctuations. …
Heater fluctations. …
Possible Leakages & Steam from engine. …
Rising Temperature and Full Expansion Tank.

How much does it cost to replace a thermostat in a refrigerator?

RepairAverage CostThermostat replacement$100 – $440Coils replacement$100 – $440Door seal replacement$50 – $440Drip pan replacement$50 – $200

What happens when a defrost thermostat goes bad?

Defrost Thermostat Specifications. … A faulty defrost termination thermostat may result in the defrost heater never heating and a solid frost buildup on the evaporator coil, which results in too warm temperatures. The thermostat contacts are normally closed and have continuity until it reaches 140 degrees.

Does the thermostat in the fridge control the freezer?

Most control panels are positioned at the top – either on the inside or outside – of the fridge freezer. Some have electronic thermostat controls, allowing you to raise or lower the temperature at the touch of a button.

Article first time published on

Why is my Kenmore fridge not cold?

Check the condenser coils to determine if they are dirty—if the condenser coils are dirty, clean them. The condenser fan motor draws air though the condenser coils and over the compressor. If the condenser fan motor is not working properly, the refrigerator won’t cool properly.

Why is my Kenmore refrigerator not cold enough?

If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. The condenser fan motor draws air over the condenser coils to cool them. The condenser fan motor is located underneath the refrigerator near the back.

What temp should a Kenmore freezer be set at?

Ideal Freezer Temperature Kenmore recommends setting your freezer compartment between 0 and 2 Fahrenheit or -16 or -17 Celsius. Food is safely frozen at this temperature, reducing the risk of food thawing out and spoiling. Slightly lower than recommended is better than slightly higher.

How do I get my thermostat unstuck?

Park your car on a flat surface and have the emergency brake on.
Wait until the morning or a few hours after driving. …
Open your car hood after your car has had some time to cool off. …
Find the thermostat. …
Remove the radiator cap. …
Have someone else start the car for you.

What to do after replacing a thermostat?

After replacing the thermostat, refill antifreeze. Leave the radiator cap off, and start the vehicle. Wait five minutes to allow all of the antifreeze to circulate throughout the engine. Turn off the engine, and allow the engine to cool.

How does a fridge freezer thermostat work?

The thermostat controls the cooling process by monitoring the temperature and then switching the compressor on and off. When the sensor senses that it’s cold enough inside a refrigerator, it turns off the compressor. If it senses too much heat, it switches the compressor on and begins the cooling process again.

How do you change a temperature control thermostat on a freezer?

Disconnect the electrical power. Unplug the freezer or shut off the circuit breaker for the freezer.
Remove the control knob. …
Remove the grille cover. …
Remove the cold control thermostat. …
Install the new cold control thermostat. …
Reinstall the grille cover. …
Reinstall the control knob. …
Restore electrical power.

How do you know if your fridge is in defrost mode?

Complete a visual inspection of the ice buildup in the freezer. If the ice appears wet or slushy, it indicates the refrigerator is in defrost mode.

Where is the thermostat located on a Kenmore upright freezer?

Located on the back wall of the freezer section in the refrigerator, the defrost thermostat is used to regulate the appliances temperature to keep the refrigerator cold and constant.

What is wrong if my refrigerator not cooling?

Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). … Clean the fan blades and spin the fan by hand to see if it’s stuck. Plug in the fridge and make sure the fan runs when the compressor is running.

Are refrigerators worth repairing?

Built-in refrigerators are almost always worth repairing. Not only are they less expensive to repair but typically have a longer lifespan anyways. Side-by-side refrigerators should be repaired within a five-year window and considered for replacement after that.

How do I fix my refrigerator that is not cooling?

Make sure your fridge is getting power. …
Take a look at your owner’s manual. …
Check the refrigerator thermostat. …
Test the seals on your fridge doors. …
Determine whether the refrigerator is level. …
Clean the condenser coils.

How do I run a diagnostic on my Kenmore refrigerator?

Enter the diagnostic mode by pressing and holding the Lock button for 3 seconds, then press and hold the Freezer and Refrigerator buttons while pressing the Acela Ice button 5 times. The digital display will show operating time (number of minutes it’s been plugged in).

Why is my Kenmore fridge not cooling but freezer works?

Check the evaporator coils to determine if they are frosted over. … If the evaporator fan is not working, the freezer or refrigerator will not cool adequately. To determine if the evaporator fan motor is defective, try turning the fan blade by hand. If the fan blade does not turn freely, replace the fan motor.

Why is my fridge not getting cold but my freezer is?

When the fridge is not cold but the freezer is, the problem is probably tied to one of your refrigerator’s mechanisms not working as designed. … A small fan and motor are mounted near the evaporator, helping draw air over the coils and circulate it to the fridge and freezer.

Why is my freezer cold but fridge warm?

It is standard to find that most refrigerators use a fan to move cold air that is in the freezer into the evaporator. Then that air is pushed into the refrigerator area to keep it at a cool temperature. When this fan is not functioning properly, your freezer may seem fine, but your refrigerator will seem warm.

What temperature should refrigerator be set at?

Keep your appliances at the proper temperatures. Keep the refrigerator temperature at or below 40° F (4° C). The freezer temperature should be 0° F (-18° C). Check temperatures periodically.

Where is the condenser coils located on a Kenmore refrigerator?

The condenser coil is located in the back of the unit by the compressor. You will need an extended condenser coil brush to reach them from the front of the unit. You can purchase this type of brush from Sears & other hardware stores.