Where is the reset button on AO Smith gas water heater?
The reset button: a red button located on the water heater itself (just above the thermostat) that trips when the water temperature exceeds 180 F. The reset button is sometimes referred to as the “ECO” (emergency cut off) or “high limit switch”.
Why my water won t get hot?
A water heater that produces no hot water may not be getting power, may have a tripped limit switch, or may have one or more failed heating elements. First, check the water heater’s circuit breaker in the service panel to make sure it hasn’t tripped. If the breaker has tripped, switch it off, then switch it back on.
Why is my gas hot water heater not working?
The other less common problem would be the gas valve. A bad gas valve will not allow any gas to go to the burner or pilot light. If the pilot light lights and then shuts off it is not the gas valve. If it won’t light at all, see the article, ‘ Fixing Hot Water Heater Gas Valves ‘ for the issues surrounding this device.
What to do when your gas water heater goes out?
Usually a good teflon tape sealant does the trick. Light the pilot according to manufacturer instructions. The gas water heater should be ready to go. What’s wrong if the pilot light will light, but when I turn on the heater it goes out? Most likely it is due to a bad thermocouple, you’ll need to replace it.
What to do if your hot water heater is leaking?
If so, reduce the water flow. Check if the gas supply is blocked in some way. Gas water heaters need optimum supply of gas at all times. If the gas line is blocked, remove the blockage. If there is even the tiniest gas leakage, replace the gas line immediately. Check that the hot and cold water lines are not crossing at some point.
Is it safe to repair a gas hot water heater?
Just keep in mind that with the potential above you might get some serious selling when you try to get someone to fix your hot water heater. Remember there is a potential danger with the gas. Natural and propane gas can explode. Never attempt a repair unless you have turned the gas off and are thoroughly familiar with safe working practices.
How do you troubleshoot a gas hot water heater?
If troubleshooting a gas water heater, make sure that the gas is on, then relight the pilot flame with a BBQ lighter at the base of the water heater. If troubleshooting an electric heater, make sure the heater is receiving electricity, then reset the thermostat by pressing down the red reset button on top of the thermostat.
Why is my hot water heater not heating?
When the upper heating element or upper thermostat is faulty, the water in the top of the tank will never reach the temperature setting on the upper thermostat and the water at the top of the water heater will not get hot. When this happens, it will never switch power to the lower thermostat or heating element.
How do you turn on a hot water heater?
Turning On Electric or Tankless Water Heaters Turn on the breaker for the hot water tank after it’s full of water. Wait several hours for the water tank to heat up. Turn off the gas before switching on your tankless water heater. Confirm the temperature and turn on the gas for the tankless water heater.
