Where is the drain line on a washing machine?
When hooking up a new washing machine, some people look for a convenient drain line and simply install a pipe that extends to the washer. If they omit the trap. The piping in the photo on the left represents a laundry sink drain, while the photo on the right depicts a washing machine’s stand pipe. In each A is the vent, B is.
How do you attach a drain hose to a washing machine?
Attach the drain hose to the “T” by squeezing the compression nut on the “T” around the drain hose. Pass an S-trap over the end of the drain hose, and tighten the compression nut to lock it in place. Cut a section of drainage pipe that will extend up to trap at about the likewise height as the back of your washing machine.
What kind of fitting do I need for washing machine drain?
Note the san-tee used to join these pipes. A horizontal drain may flow to the vertical with a medium sweep fitting. A san-tee forms a medium sweep 90 degree elbow so we are allowed to use it to join a horizontal drain to a vertical drain. This photo shows a washing machine drain joined to a laundry sink drain.
Where does the water from a washing machine go?
This is a pipe joined to a trap which in turn connects to the primary collector of your house. Form the drain pipe of your washing machine goes into the vertical riser. Like the drains of the washing machine, the pipe transfers the drain water from the machine to the pipe and through the main drain of your house.
When hooking up a new washing machine, some people look for a convenient drain line and simply install a pipe that extends to the washer. If they omit the trap. The piping in the photo on the left represents a laundry sink drain, while the photo on the right depicts a washing machine’s stand pipe. In each A is the vent, B is.
How to install a drain pipe for a washer and dryer?
Run a length of 2-inch ABS pipe to the wall behind the washing machine. At some point within five feet of the washer, install a 2-inch sanitary tee with its outlet facing upward. This tee is for the vent pipe. Stub the pipe out about 2 inches from the wall and 36 to 42 inches above the floor. Glue on an ABS P-trap.
Note the san-tee used to join these pipes. A horizontal drain may flow to the vertical with a medium sweep fitting. A san-tee forms a medium sweep 90 degree elbow so we are allowed to use it to join a horizontal drain to a vertical drain. This photo shows a washing machine drain joined to a laundry sink drain.
Do you need a trap to drain a washing machine?
Washers, like all fixtures, need a trap. The correct way to drain a washing machine is to install a standpipe. That is a vertical length of pipe that connects to a P-trap that, in turn, connects to the drain.
