What size tubing is used for refrigerator ice maker?
The tubing should have a diameter of 1/4-inch and can be copper line, braided steel line or plastic tubing. Many professionals prefer copper line, but plastic tubing is commonly sold as part of ice maker installation kits.
Where is the water fill tube on an ice maker?
If you notice that your ice maker is not making or dispensing ice, or is leaking, you may need to replace the water fill tube. This water fill tube kit comes with a fill tube and a compression nut. This part is made of white plastic and is approximately 10 inches in length. The ice maker water fill tube is in the rear of the fridge.
What do I need to replace my ice maker?
Connect the wiring harness of the new ice maker to the wiring connection point, which is positioned behind the electrical access panel; Fix the ice maker in place with two mounting screws and an L bracket; Position the water tube into the water inlet hole and fasten it tight; Put the Styrofoam insulation over the fill tube.
What kind of tubing do you need for an ice maker?
Plastic tubing is less expensive and easier to install than copper. You then need to connect the tubing at the back of the refrigerator. An ice maker kit will provide all the fittings necessary to connect your ice maker to the plastic water tubing.
How do you install an ice maker in a refrigerator?
Push the tube seal over the water inlet tube threads. Thread the nylon compression nut onto the threaded end of the water inlet tube. Tighten the compression nut to finger tight and then tighten the nut another 1/2 turn using a wrench. Do not over-tighten the compression nut. Install the adjustable leveling bracket on the bottom of the ice maker.
What kind of tubing do I need for an ice maker?
The tubing should have a diameter of 1/4-inch and can be copper line, braided steel line or plastic tubing. Many professionals prefer copper line, but plastic tubing is commonly sold as part of ice maker installation kits .
What should I replace the water line on my ice maker?
If that plastic water line behind your fridge that feeds the icemaker makes you nervous about water damage, replace it with a stainless steel line and copper shutoff valve. Unscrew the valve and slide it aside.
What do you need to connect an ice maker to a refrigerator?
You then need to connect the tubing at the back of the refrigerator. An ice maker kit will provide all the fittings necessary to connect your ice maker to the plastic water tubing. Before installing the plastic tubing into the refrigerator fitting, cut the tubing to an appropriate length.
If you notice that your ice maker is not making or dispensing ice, or is leaking, you may need to replace the water fill tube. This water fill tube kit comes with a fill tube and a compression nut. This part is made of white plastic and is approximately 10 inches in length. The ice maker water fill tube is in the rear of the fridge.
