What size are tap connectors?
The most common length of flexible tap connector is 300mm although some variations come in 150mm, 500mm and 1000mm.
Are bath and basin taps the same size?
Basin taps Pictured is a basin tap, with a 15mm thread. Bath taps look very similar, except they have a 22mm thread and may be joined together as a mixer.
Can a plastic tap be connected to plastic pipes?
However, you can only use one of these kits if you have copper pipes. Unfortunately, my water pipes are plastic so I had to find a different way of connecting my tap. It’s worth noting that you can still use this method if you have copper water pipes!
Do you need rigid pipes for mixer tap?
Hand tight only needed with them. Wet your finger and run it round the o-ring before fitting just to make sure if sits properly. So my current mixer tap has rigid pipes cut to size go to it.
Is it possible to fit an outdoor tap?
If you don’t have an outdoor tap, it can be a real pain to clean in the garden, water plants, even fill pets’ water bowls. I fitted a garden tap yesterday. Before that I needed to attach a hose to the kitchen tap and run it out the window – not ideal! The outdoor tap took just half an hour to fit and is going to get so much use.
Do you need a flexible fitting for a kitchen tap?
Flexi terminations vary. Compression ones have a normal compression joint which must be tightened. Push fit do as they say but the tube MUST be cut with a pipe cutter, NOT a hacksaw. If your tap needs NRV’s fitting then these will have to be put in as well. Don’t forget it’s mains pressure too so get it wrong and expect big leaks.
However, you can only use one of these kits if you have copper pipes. Unfortunately, my water pipes are plastic so I had to find a different way of connecting my tap. It’s worth noting that you can still use this method if you have copper water pipes!
What do you need to know about outdoor tap fittings?
There are a couple of regulations that you need to take into account when fitting your outdoor tap: your tap must have a double check valve. This basically ensures that the water supplied to the outside tap doesn’t make its way back into your inside water mains You must fit an isolation valve.
Why are the pipes on my kitchen tap not flexible?
The pipes have been soldered onto the side of isolation switch so they do not follow the pipes’ natural path. There does seem to be some kind of join in the vertical section of the pipes, (where they run up the bottom of the tap), but I think the join is soldered as there’s no obvious nut to link the two sections.
Is there a two way tap for a washing machine?
A two way tap for your washing machine can split the tap into two separate options for water pressure. This ensures that one tab can stay hooked up to the washing machine permanently, while the other occasionally connects to your water pressure machine.
