What should the pressure be on a glow worm 30cxi?
Cold pressure setting should be 1.0 bar ( I set em to 1.2 usually). As the system heats up the water in it expands, and the pressure rises to the sort of figures you are seeing 1.5 to 2 bar. as long is it goes no higher there is no problem. It will drop again as it cools.
How do I reset my Glow Worm boiler 30cxi?
Turn the Mains Reset Switch to 0, wait for 5 seconds, turn Mains Reset Switch to 1, the boiler is reset.
How do I get the pressure out of my Glow Worm boiler?
The most common way of resolving this is to drain water from the radiators. Open the valve, using a radiator key, until the water pressure reading on your boiler drops to around 1.3 bar. When you open the valve, you’ll hear the air escaping, and then the water will start to drain.
Is the glow worm 30cxi-ch but no hot water?
I have no error lights, the LED is green and I can hear the boiler firing up. I tried the bathroom taps and it was the same in there. The radiators warm up when the hot water is on but ch off.
Is there an F1 fault on glow worm 30cxi?
Just had the F1 fault on my Ultracom 30SXI. Over the last week I have suddenly got got the fault on almost a daily basis but was cleared after pressing the recessed reset button. When the fault occurred I could hear the boiler start and what sounded like ignition then cut out a number of times.
What are the problems with the glow worm boiler?
Top 6 Glow-worm Boiler Problems Glow-worm Boiler Problems Glow-worm Error / Fault Code Low water pressure 108 or F22 Flame detection fault F16 No heating or hot water 501 Frozen condensate pipe F1, F4, F28 or F29
What is the fault code on a flexicom glow worm boiler?
Fault code F14 (Flexicom CX range) If you were to look at the service manual, you’d find this fault states there’s a defective gas valve. However, check there is power from the PCB to the gas valve. If not, it’s not the gas valve at all, but either the PCB or the wiring harness.
Why is my Glow Worm CXI boiler not working?
On the very first note, the process of re-pressurizing for the 30 and 24 output ranges of Glow worm cxi boiler is same as the models differ just in the output served. In case if your central heating system is not working properly, it could be because of the loss of water pressure.
What happens if a glow worm is not closed?
However if it is not closed it will slowly leak additional water into the boiler. This will increase the pressure and the boiler will lockout. Note –If there is no filling loop in your boiler, they might be installed on the cylinder. If you have re pressurized your boiler too much you will need to drain the system.
Why is my Glow Worm 30cxi diverter not working?
I took the motor off the Diverter valve and the pin in the valve is able to be pushed in by the motor to the ch position, but is jamming and won’t return to the hw position. I managed to get some long nosed, right angle pliers on the pin to give it a pull and hw was restored – but the pin is still stiff. I assume I need a new div. valve cartridge?
When to get a quote for a glow worm boiler?
Get a quote to repair your boiler now. 1. Low boiler pressure (108 or F22) If the pressure gauge on your Glow-worm boiler is showing anything below 1 bar then you may have an issue which can lead to your central heating system not functioning as well as it should.
