What should I use to replace my gas water heater?
At a minimum make sure you have pipe wrenches, a tubing saw, pliers, PTFE tape, sandpaper, PVC glue (if your pipe is PVC), a coupling, and the proper replacement valve. Step 1: Turn off the electricity for electric water heaters and set the gas control valve to pilot on gas water heaters, then drain all the water out of the tank.
How does the gas valve work on a hot water heater?
See the article ‘ Gas Hot Water Heater Troubleshooting ‘, if you are unsure of your problem. The gas valve sends gas to both the pilot light and the main burner. It senses electrical current from the thermocouple and shuts off the gas if the pilot is not lit. This is an important safety feature.
What to do with old water heater valve?
With the old valve off, you’re ready to screw in the new one. Before sticking the valve into the tank, wrap the end in PTFE tape in the opposite direction you’ll be screwing it in.
What to do if your hot water heater is not turning off?
The first thing you need to do is shut off the gas to the hot water tank. This is done at the shut off valve that is in the gas line. Turning the water heater gas valve to off is not the place to do this. The ‘Off’ position on the gas valve dial only means that it will not heat the water.
How do you replace a gas control valve on a water heater?
Take the original valve with you to the hardware or gas supply store to get a matching replacement. Reconnect the new valve in reverse order. If you do not detect gas or a rotten egg odor, relight the pilot and verify that the water heater is working properly. Newer models may have wires connected to the gas control valve.
Where can I get a replacement gas burner for my water heater?
If your water heater pilot, gas valve, or burner assembly is malfunctioning, Repair Clinic can quickly ship you the exact replacement part that matches your product. Just enter the full model number of your water heater in our website’s search bar for a complete list of parts associated with your particular water heater.
What should I install in my hot water heater?
Make sure you connect each to the correct side of the valve. Install shut-off valves (5) in both the hot water feed and the cold water feed to give you additional control. Close each valve off. Plan where to cut into each pipe and work out the new route for the piping through the shut-off valves to the thermostatic valve.
What does it mean when your water heater valve is off?
The ‘Off’ position on the gas valve dial only means that it will not heat the water. The pilot light is still on and gas from the main supply line is still on. You need to turn the inline valve ninety degrees so that it is perpendicular with the gas line. Next you want to run some hot water into a sink until the water cools down to lukewarm.
