What kind of wall tape do you use for shower walls?
We mainly used the heavy-duty mesh stuff for the shower walls. Tape, mud, sand, mud, sand, repeat. We enlisted the help of our friend Andy who is basically a professional at taping and mudding walls. It’s an art form.
What kind of tape do you use on draywall walls?
Also, mud over the joints with FibaTape to secure it. No sanding required. This is FibaTape (mesh draywall joint tape). Use it to secure a seam over each joint with mud. Here’s what it all looked like while doing the final slope pour.
Where to put drain and vent lines in a bathroom?
Drain and vent lines must be positioned precisely, so you should install them before the supply pipes. It may be possible to simplify supply runs by moving a vent pipe over a few inches.
What are the pipes sticking out of the wall?
The original piping, usually galvanized steel or copper, has been sawed off near the wall and left in place, like in the photos below. One set of abandoned pipes below is open and the other set has been sealed. Again, the best solution is removal of the abandoned pipe and repair of walls.
Why do you wrap tape around plumbing pipe?
When the pipe is turned into the fitting, the friction of the mating threads should work to tighten the tape around the pipe, rather than work against it and unravel or ball up the tape. Therefore, you wrap the tape around the pipe in the opposite direction of how the pipe will turn into the fitting.
Can you use plumber’s tape for pipe dope?
Plumber’s tape is recommended for use with most threaded connections that don’t have a built-in rubber seal. If you’re familiar with using pipe-joint compound (a.k.a. pipe dope), you can substitute with plumber’s tape in the same applications.
What kind of tape to use on gas pipe?
It can be used on all standard metal pipe materials as well as rigid plastic pipe. Common places to use plumber’s tape include: Note: Plumber’s tape can be used on some gas-pipe connections, but this requires a special type of plumber’s tape, typically colored yellow, that is rated for gas lines.
How to run pipes through walls and floors?
Guide the vent pipe up through the hole and into the attic or room above and slip its lower end into the fitting at the floor. Whenever possible, run pipes through holes in the center of framing members. To keep pipes from rattling, line the holes with felt or use wood shims.
