What kind of tubing do you use for a water softener?
You will need to purchase flexible 1/2″ ID (5/8″ OD) plastic pipe. You can use braided vinyl, polyethylene, or PEX pipe. The plastic piping should have a minimum pressure rating of 75 psi. The same size and type can be used in steps 4 and 8.
Can I use PEX for water softener drain line?
I use PEX on my softener and iron filter drains as well as the furnace condensate line. With the exception of the one end, therre is no need for fittings or joints anywhere else.
Is polyethylene tubing OK for hot water?
What is polyethylene tubing? Polyethylene tubing offers excellent pressure and temperature ratings and has outstanding resistance to environmental stress cracking. LLDPE is more robust than traditional low or medium density polyethylene and is recommended for use with cold and intermittent hot water.
Can vinyl tubing be used for hot water?
Flexible vinyl tubing is easy to connect using a variety of barbs, clamps and fittings. Temperature range is particularly important for tubes supplying hot water.
Can you run a water softener drain overhead?
The softener discharge is connected to a potable water source, so you cannot legally connect its drain to the floor drain. It is supposed to be at least 1″ above the floor drain and flow out of the pipe into the drain across the 1″ air gap.
Is there a 2 in plastic water softener?
It allows a soft rubber washer hose or aluminum washer drain to hook up to a standpipe, fitting 1-1/2 in. and 2 in. metal or plastic standpipes. It is constructed of heavy duty plastic for long-term durability. For use with washing machine discharge, dehumidifiers, water filtration devices, and water softeners
Where does a water softener drain line go?
A softener drain line must not be connected directly to the waste system, but must be emptied into a laundry tray, floor drain, or properly trapped special outlet, preserving an air gap of at least two times the diameter of the drain line, but in no case less than 1-1/2″ above the top of the receptacle used.
How to install an outlet for a water softener?
If you want an outlet, such as a hose bibb, to carry hard water, install a T fitting prior to the softener and run it to the outlet. 4 Cut and install the pipes that lead to the bypass valve. Solder all the fittings and nipples before attaching them to the plastic bypass valve (the heat from soldering could damage the plastic).
How big of an ID do you need for a water softener?
You’ll need 5/8-inch ID for the same distance if the discharge is slightly higher than the inlet. For a distance of 15 to 25 feet and/or if the drain is above the inlet, opt for 3/4-inch ID. The drain line should not be positioned more than 10 feet above the floor. Be sure to follow the manufacturer’s instructions.
