What kind of power does a jet pump use?
This 1/2 HP convertible jet pump can be configured to run on a 115V or 230V power supply. This pump is excellent for delivering fresh water only to rural farms, homes and cabins. Water may also be sourced from a lake or well.
Can a jet pump be set to 2 pipe?
This pump can “convert” from a single pipe application with a maximum 25’ suction lift to a 2 pipe application that can be set to pump from water depths of up to 80’. The pressure setting is factory set to a 30/50 setting and has a 1.25” intake and 1″ discharge. The injector for the 2 pipe application is included.
What kind of jet pump do I need for shallow well?
If the pump is no higher than 25’ above the bottom of the tank, use a shallow well jet pump. If it’s further down, use a convertible deep well jet pump. If the tank is above ground and the pump next to it, use a shallow well jet pump.
What kind of motor does a Myers shallow well jet pump use?
Construction: Cast iron body with lexan impeller Motor: GE capacitor start, two compartment square flange 56Z motor. Inlet & outlet: 1-1/4 X 1″ FNMT Electrical: 115/230 volts, 1 phase, 60 Hz, 1/2 HP, 10.6/5.3 amps, Pressure switch setting: 20 PSI cut-in; 40 PSI cut-out. Myers Shallow Well Jet Pump 12 GPM 1/2 HP # HR50S.
What kind of motor does a jet pump use?
Construction: Cast iron body with lexan impeller Motor: GE capacitor start, two-compartment square flange 56J motor. Inlet & outlet: 1-1/4 X 1″ FNMT Electrical: 115/230 V, 1 PH, 60 Hz, 3/4 HP.
This pump can “convert” from a single pipe application with a maximum 25’ suction lift to a 2 pipe application that can be set to pump from water depths of up to 80’. The pressure setting is factory set to a 30/50 setting and has a 1.25” intake and 1″ discharge. The injector for the 2 pipe application is included.
Which is the best shallow well jet pump?
The Wayne 1/2 HP Cast Iron Shallow Well Jet Pump features a high-efficiency square-flange motor that is thermally protected to help prevent overheating. The volute is constructed of durable cast iron, with a corrosion resistant, reinforced thermoplastic impeller and diffuser. The pump includes a dedicated priming port for convenient volute filling.
Construction: Cast iron body with lexan impeller Motor: GE capacitor start, two compartment square flange 56Z motor. Inlet & outlet: 1-1/4 X 1″ FNMT Electrical: 115/230 volts, 1 phase, 60 Hz, 1/2 HP, 10.6/5.3 amps, Pressure switch setting: 20 PSI cut-in; 40 PSI cut-out. Myers Shallow Well Jet Pump 12 GPM 1/2 HP # HR50S.
