What kind of motor does Autotrol water softener use?
Autotrol is a vertical manufacturer of things like water softeners.They also produce a wide range of custom AC magnet synchronous geared motors and DC geared motors. The company was founded in 1964. It is well known for its wide range of applications and its knowledge about geared motors.
Is the Autotrol 255 control valve NSF / ANSI 44 or 61?
The 255 water conditioner’s control valve conforms to NSF/ANSI 44 and 61 for materials and structural integrity only. Generic systems were tested and certified by WQA as verified by the performance data sheet. • Please review this entire Installation and Operation manual before installing unit.
What kind of tubing is needed for Autotrol 255 valve?
For such installations, use an appropriate adapter fitting (not supplied), to connect 1/2-inch (1.3-cm) plastic tubing to the drain line connection of the control valve. 2. If the unit is located more than 20 feet (6.1 m) from drain, use 3/4-inch (1.9-cm) tubing for runs up to 40 feet (12.2 m).
Is the 255 valve on a water conditioner safe?
Safety Information The 255 water conditioner’s control valve conforms to NSF/ANSI 44 and 61 for materials and structural integrity only. Generic systems were tested and certified by WQA as verified by the performance data sheet. • Please review this entire Installation and Operation manual before installing unit.
How long does a Autotrol softener control valve last?
The expected life span of the Autotrol softener control valve is 20 – 30 years with a few minor repairs along the way. The Flapper Valve Discs in the valve body generally need replacement after 15 – 20 years.
When to replace flapper valve on Autotrol 155?
However, if your system is on a chlorinated water source, the Flapper Valves ( part # 155A152 ) will need replacement much sooner ( 5 – 10 years is common ). On chlorinated water supplies it is also necessary to replace the Flow Control Ball ( part # 4F ) which sits inside the Backwash Plug on the right rear of your valve.
Where is flow control ball located on Autotrol 155?
On chlorinated water supplies it is also necessary to replace the Flow Control Ball ( part # 4F ) which sits inside the Backwash Plug on the right rear of your valve. In severe cases it made be necessary to replace the injector ( # 28F-BB ) also. There is no need to change other parts or o-rings unless you have a leak.
Autotrol is a vertical manufacturer of things like water softeners.They also produce a wide range of custom AC magnet synchronous geared motors and DC geared motors. The company was founded in 1964. It is well known for its wide range of applications and its knowledge about geared motors.
The expected life span of the Autotrol softener control valve is 20 – 30 years with a few minor repairs along the way. The Flapper Valve Discs in the valve body generally need replacement after 15 – 20 years.
However, if your system is on a chlorinated water source, the Flapper Valves ( part # 155A152 ) will need replacement much sooner ( 5 – 10 years is common ). On chlorinated water supplies it is also necessary to replace the Flow Control Ball ( part # 4F ) which sits inside the Backwash Plug on the right rear of your valve.
On chlorinated water supplies it is also necessary to replace the Flow Control Ball ( part # 4F ) which sits inside the Backwash Plug on the right rear of your valve. In severe cases it made be necessary to replace the injector ( # 28F-BB ) also. There is no need to change other parts or o-rings unless you have a leak.
