What is the standard toilet water supply line?
Typically they are 3/8” in diameter, but toilet supply line size can vary in length, usually anywhere from 9” to 20”.
What side is the water supply on a toilet?
Originally Answered: Can you install the water supply on the right side of the toilet tough in? Yes, but toilets in the US are made to have the inlet on the left. If you put the supply on the right you will need a long and unsightly supply line from the stop valve to the toilet inlet.
Where is the water line in a toilet?
The toilet supply line is attached to a cold fresh water pipe under the slab or in the wall to the toilet tank. The water from the cold line runs through the supply line to fill the tank which then fills the bowl after you flush the toilet.
What’s the best way to tighten a toilet supply line?
A flexible toilet water supply line is a little easier to tighten. It is still a good idea to use two wrenches. This is just to make sure that you don’t damage anything else. Tighten the fitting that is leaking a quarter turn at a time until the leak stops. Use a dry rag and your finger to check for leaks. Replacing the supply line is pretty easy.
Where does the water come from to flush the toilet?
The first step with any leak is not a surprising one: Find it! The toilet supply line is attached to a cold fresh water pipe under the slab or in the wall to the toilet tank. The water from the cold line runs through the supply line to fill the tank which then fills the bowl after you flush the toilet.
What are the different types of toilet supply lines?
Types of Toilet Water Supply Lines 1 Chrome Plated Brass. In the past you had to purchase a 3/8″ brass tube that had a special flared end on it. 2 Flexible Supply Lines. A more popular choice in recent history is a flexible line with factory installed fittings. 3 Tightening a Leaking Supply Line. 4 Replacing a Toilet Supply Line. …
What is the best water supply line for a toilet?
The water supply line for a toilet typically stubs out of the wall just under the toilet tank on the side where the water inlet on the tank is located. One-half-inch copper pipe is the most common material for the line, and it can tie into any existing 1/2- or 3/4-inch cold water line — the nearest one is usually the best.
How do you replace a toilet water line?
Take the adjustable crescent wrench and loosen the nuts at the base of the toilet and at the water supply valve. Once the nuts have been loosened with the wrench, continue turning them counterclockwise until you can remove the water supply line. Discard the old water supply line hose.
What causes a toilet supply line to leak?
Quite often, a faulty supply line will cause the toilet to leak. When joints in the supply line become loose or wear out, they allow water to seep through. The rubber lining in the supply line used to guard against leakage may also wear out or rupture. Mechanical damage caused to the supply line can also cause leaking.
How long do toilet supply lines last?
A neighbor’s home was sadly flooded by an older toilet. The water supply line going to the tank of your toilet should be replaced at least every 8 years.
