What is the ground clearance for a water meter?
The water meter assembly must be fully supported with minimum ground clearance of 150mm, and should not be greater than 300mm from the finished ground level to the base of the water meter assembly (where the Backflow prevention device is a Reduced Pressure Zone type, a minimum 300mm to the device vent is required).
Where does a water meter have to be on a property?
The water meter assembly must be within one metre of the property boundary that fronts the water main.
What to do if your water meter is damaged?
If your water meter has been damaged and you need a replacement meter, a licensed plumber is required to repair your water service and affix a spacer on the meter frame. You or the plumber can complete our Damaged Meter Replacement Form. Are you undertaking separate metering for a Community or Strata title development?
Why is my water meter spinning in Las Vegas?
Routine monthly expenditures are the bane of homeowners and tenants everywhere. However, some of those reoccurring bills can be reduced by changing bad habits or fixing possible issues that you were previously unaware of. Water usage is one of the bills that can be put under control even in our arid Las Vegas environment.
Is there a deduction for an irrigation meter in Houston TX?
For many Houston area home owners this could easily mean a $60 to $100 deduction from their water bill during the warmer months. Here’s how it works: The city will install a second irrigation water meter right beside your existing meter, usually in the same box.
How much does a water meter in Houston cost?
The cost of this second meter is usually pretty steep. Most of the Houston area can expect to spend between $1,800.00 and $3,000.00 for a meter like this with most of that money going to the city for permits, the meter itself and the city plumber (note that only a city plumber can install such a meter).
How much does an irrigation water meter cost?
The cost of this second irrigation water meter is usually pretty steep. Most of the Houston area can expect to spend between $1,800.00 and $3,000.00 for a meter like this with most of that money going to the city for permits, the meter itself and the city plumber (note that only a city plumber can install such a meter).
How to check a water meter to find plumbing leaks?
Slab Leak: If the leak is in or under a concrete slab, you will need to disconnect the leaking pipe, then run a new water line through the attic and down a wall. If the meter does not indicate a leak, contact your water company and have them check the meter to be sure it is working properly.
