What is the code for shower?

Shower and Bathtub Code and Spacing Practices Shower maximum sizes are not mandated, but minimum sizes are regulated. Shower floor minimum size is usually mandated to be at least 30 inches square; that is, 30 inches by 30 inches.

Is it code to have a bathtub?

The Housing Maintenance Code requires each dwelling unit in a one or two family home to have either a shower or a bathtub. Replacing one with the other, therefore, should be permissible.

What is code for a walk-in shower?

The ADA suggests a minimum size of 36 inches by 36 inches for a walk-in shower, which features a bench attached to one wall for sitting. Even if you eschew the bench, 36 inches by 36 inches is a good minimum size for ease of showering.

Why put a bathtub in the shower?

Placing the tub inside the shower means the entire area is waterproofed, and it actually simplifies the room’s design. Tip: If you plan to wash your kids in the tub, place the shower fixtures so they can be used in both the tub and the shower to make things easier.

What is the building code for a shower?

The code also states “this space is all encompassing and includes the space directly over the tub or shower stall.” Fixtures installed within this tub or shower area should be marked “Suitable for Damp Locations” unless exposed to shower spray in which case they must be marked “Suitable for Wet Locations.”

Can a shower be installed next to a bathtub?

Rather than referring to the bathtub or shower zone, as was done for luminaires, this section addresses the footprint of the bathtub or shower stall. Receptacles installed adjacent to a bathtub or a shower stall would not be a violation of this section.

When did the building code require safety glass for bathrooms?

This bathroom window safety glass requirement has been with us since 1991 edition of the Uniform Building Code. However, almost every single home inspection I perform in a new construction or gut-rehabbed properties fails on the bathroom window… obviously; it’s not an important requirement.

Where is the shower zone in a bathroom?

The Shower Zone. Zone is the area measured three feet horizontally and eight feet vertically from the top of the bathtub rim or shower stall threshold. In small bathrooms, measuring three feet horizontally from the edge of the bathtub rim or shower stall threshold can often include wall-mounted luminaires located directly above an adjacent sink.

Do you have to have a building code for a shower?

The shower and tub both need anti-scalding devices. This is a device that should be included even if it wasn’t mandated by a bathroom building code. Too many tragedies involving young child occur with scalding hot water surprisingly coming from the shower or bathtub faucet. The shower door needs to have an opening clearance of at least 24-inches.

What is the building code for a bathroom?

Measure 3 feet away from the tub rim horizontally and 8 feet up from that point. This defines the boundary surrounding the tub. The code also states “this space is all encompassing and includes the space directly over the tub or shower stall.”