What is the Blue Thing in the cold water side of the hot water heater?

The blue thing in the cold water side of the heater is called a “dip tube” it is there to carry the cold water entering the heater to the bottom of the heater and not mix at the top of the heater with the water that has already been heated. Thank you sooooo much. I really appreciate it a ton. I would hold out for an answer from Tom.

What to do if your washing machine water inlet valve is blocked?

Direct the loose end of each hose into the bucket to drain water from the hose. Check for clogs in the filter screens in the water inlet valve, which can block water flow.

How do you replace a Maytag water inlet valve?

Tilt the console open so the back lifts up and rotates so the console rests on top of the washer. Then locate the blue water inlet assembly on the right side. 3. Remove the water inlet valve assembly. Start removing the wiring harness. To do that, move to the left side of the console and cut the zip tie holding the left bunch of wires.

Where are the plastic inserts in my hot water heater?

In the Water heater, Model # 153.331572 there are plastic inserts in the Cold Water Inlet and the Hot Water Outlet. What are they for? Should they or can they be removed be removed? There is no information in the installation manual. Share it! Click to remove this tagging. I can understand your confusion upon the water heater.

How do you clean the water inlet valve on a washing machine?

Brush out any dirt or grit. You can soak the inlet screens in a mild solution of water and vinegar if they are calcified. Insert the clean water inlet screens back into the inlet valves on the washer. Attach the water supply hoses.

What happens if you block the inlet valve on a washing machine?

Over time, however, such debris will become so backed up around the filter that it will restrict the flow of water into the machine. This may present two problems. First, it will slow the entry of water into your washer. In some cases, if the build up becomes thick enough, it may prevent water from entering the machine altogether!