What does it mean when water heater light is blinking?
1 flash every 3 seconds means the pilot is lit and the gas valve is working normally. A solid red status light means the water heater is shutting down. Remember, 1 flash every 3 seconds means the pilot is lit and the gas valve is operating normally.
When to troubleshoot a Rheem tankless water heater?
1. Troubleshooting: Error No Code This happens mainly when the flow rate is low and there is a complete maintenance error. In such a situation, the control board simply displays the current temperature and the heater does not work at all. The first thing that you need to do is to adjust the flow or the temperature.
What does the Rheem error code 65 mean?
Rheem error code 65 means there is a problem with the water volume control. While troubleshooting, Rheem error code 65, confirm the unit receives enough water and all wiring connections are in good working condition and tight. Replace the water control assembly or the PCB if necessary.
What does Rheem code 13 mean on a water heater?
Rheem error code 13 indicates a problem with the flame rod, which is typically accompanied by poor or improper combustion and found on indoor units. Inspect the condition of the flame rod and blower motor, the air intake, and exhaust vents.
Why are the lights on on my Rheem water heater?
The lights on the control panel are on, so it seems to be on. If the high limit switch kicked in, I’d expect at least a couple red lights. The thermostat could be set too low. This is not like the house thermostat; we don’t have thermostat wars over the hot water level, especially when you can up the percentage of cold water if you don’t like it.
Is the service needed light blinking on my Rheem water heater?
Today the Service Needed light started blinking – 5 times and then a pause. I see that … read more I have the Rheem short 30 gallon hot water heater with the electronic ignition.
Where to find the Rheem error code on my water heater?
The error code is displayed on the LED display panel on the front of your continuous flow water heater. Please refer to the below listing to see what your error codes means, then call Rheem Service to book a service call on 13 10 31.
What do you need to know about Rheem water heaters?
Rheem water heater troubleshooting allows you to find pressure relief valve to some common issues or indicates professional repair or replacement is needed. This guide to common water heater problems covers gas and electric models from Rheem, Ruud, and other brands.
What should I do if my Rheem tankless is not working?
Check the flow from the hot water tap: You may need to clean the aerator. Wash the inlet water filter: Remove the filter and wash it under running water. Adjust temperature or flow rate: Raise the flow rate or increase the temperature. Inspect the flow sensor: Ensure the flow sensor works properly.
