What does a circ pump do in a hot tub?
A Circ Pump is a low-flow pump that comes standard on most hot tubs carried by The Spa and Sauna Co. A Circ Pump keeps the water in a hot tub circulating at all times. This is done so the water inside the hot tub is being filtered, heated, and treated with sanitizer 24/7.
How many pumps do I need in a hot tub?
A bigger hot tub will usually have more than one pump because there is room for more jets, whereas smaller hot tubs make only need a single pump. Also, you will find ‘low power’ hot tubs (13 amp) models are constricted by the electric supply meaning only one pump can be fitted.
What kind of circulation pump does Sundance Spa use?
Note: This test only works on 850 Series with Circulation Pump prior to 2001: Try turning the #1 pump which is 2 speed.
What kind of circulation pump does a jacuzzi use?
2002+ Jacuzzi J-300 Circulation Pump 240V 50/60 Hz with Cord This 6000-125 is for all Jacuzzi J-300 240 Volt models. Use the connector from the old circulation pump. The Ecocirc auto and vario were designed with the highly efficient electronically commutated permanent magnet motor (ECM technology).
What to do if your circ pump is not running?
If your pump is receiving the specified voltage but is not running, then replace the circulation pump. If is not receiving voltage but it should be, then you likely have a circuit board issue. Now, if your circ pump is running and the flow switch appears physically in the closed position, then test the flow switch. 4.
How to test the flow switch on a circ pump?
Now, if your circ pump is running and the flow switch appears physically in the closed position, then test the flow switch. 4. To test the flow switch, set your meter to ohm’s. If your flow switch appears visually closed, and you test across those two wires, your should be getting roughly 0 ohm’s or no resistance.
Note: This test only works on 850 Series with Circulation Pump prior to 2001: Try turning the #1 pump which is 2 speed.
2002+ Jacuzzi J-300 Circulation Pump 240V 50/60 Hz with Cord This 6000-125 is for all Jacuzzi J-300 240 Volt models. Use the connector from the old circulation pump. The Ecocirc auto and vario were designed with the highly efficient electronically commutated permanent magnet motor (ECM technology).
If your pump is receiving the specified voltage but is not running, then replace the circulation pump. If is not receiving voltage but it should be, then you likely have a circuit board issue. Now, if your circ pump is running and the flow switch appears physically in the closed position, then test the flow switch. 4.
Which is Sweetwater Spa offers the best hot tub?
Sweetwater Spas constantly strives to offer the finest hot tub available, therefore modifications and enhancements may be made which affect the specifications, illustrations and/or instructions contained herein. FCC Notice
