What do I do if my toilet handle is broken?

What do I do if my toilet handle is broken?

How to Replace a Toilet Handle

1. 1) Open the Tank. Remove the tank lid and set it on a spread-out towel in an out-of-the-way spot (be careful — porcelain is brittle).
2. 2) Unhook the Lift Chain.
3. 3) Remove the Old Handle.
4. 4) Purchase a Replacement.
5. 5) Attach the New Handle.
6. 6) Attach the Chain.

How do you replace a broken toilet handle?

Slide the nut back over the arm and hand-turn it onto the handle base — again, remembering that it’s likely a left-handed thread. Use a crescent wrench to firm it up, but don’t over-tighten or you could crack the porcelain. Clip it to the same hole as on the old arm. Then do some test flushes.

What happens when you change the handle on a toilet?

If too tight, the chain may prevent the flush valve from seating properly, causing it to leak continually. Adjust by switching which hole the chain is clipped to, or by adjusting the chain up or down a link or two. Keep testing until the flush works just right. Once you’re satisfied, replace the tank lid and you’re done.

What to do when the chain on your toilet breaks?

When a chain breaks, the flush lever will hang down or simply bounce back and forth. Remove the lid from the tank. Place the lid out of the way on the floor or sturdy table to avoid knocking it onto the floor. Turn off the water supply running to your toilet. Locate the knob behind your toilet and turn it clockwise until it’s tight.

Can a plumber replace the handle on a toilet?

However, in some cases, the handle itself can become corroded or any one of the pieces that connect the handle to the flapper (including the handle, nut, metal rod, or chain) can break. All of these parts can be replaced on the cheap, though. Before you call a plumber to unclog a toilet, there are two things you should try.

What to do if your toilet handle is corroded?

In most cases, if pressing the lever doesn’t flush the toilet, you can just pop the tank open and re-attach the chain. However, in some cases, the handle itself can become corroded or any one of the pieces that connect the handle to the flapper (including the handle, nut, metal rod, or chain) can break.

How do you flush a toilet with a broken chain?

Flush the toilet manually to drain the water from the tank. When a toilet flushes, the flush lever pulls the chain to lift the flapper valve at the bottom of the tank, releasing the water. Lift the valve by hand, or with the broken chain if it’s still connected to the flapper, and allow the water to run out of the tank.