What connects to a flare fitting?
A nut draws the flared tubing against a correspondingly shaped fitting, creating an extremely strong joint. In residential settings, flare connections are employed with the soft copper tubing used for gas and fuel-oil lines.
What are brass flare fittings used for?
Brass SAE 45° fittings are designed for use on low pressure copper, brass, aluminum or steel tubing. They are most commonly used for fuel equipment, plumbing, gases, refrigeration and vacuum lines. …
How do brass flare fittings work?
Flared Outlets: It’s placed around the diameter of the pipe near the end in a hole appropriate to that size of pipe, with a flared shape that will form the flare. Once it’s secured, another tool is put into position that, when screwed down, will deform the pipe, creating a flare or cone at the end.
How much pressure can a brass compression fitting hold?
Maximum working pressure is 400 psi.
How do you flare a brass tube?
Flaring the tube This you do by holding the tube at an angle against a steel plate or other hard surface, and rubbing the end of the tube, while turning it and pressing down, to burnish it around and shrink the flared end.
How much psi can compression fittings hold?
PVC Compression Coupling has a maximum working pressure of up to 200 psi. Compression fittings are the perfect choice for high pressure applications. In combination with a high pressure tubing material like steel, large compression fittings can often be used at pressures in excess of 10,000 psig.
Is it OK to use brass flare fittings?
Since natural gas can contain some hydrogen sulfide, these brass flare fittings are not recommended. Galvanized and black steel pipe and fittings can be used if it is standard weight Schedule 40 or thicker.
What kind of connector for a Fairview flare?
Fairview’s Female Flare Male Pipe Connector SAE 45° Flare Fittings are ideal for use with LP-Gas, Natural Gas, Refrigeration, Gasoline and more
Where to buy flare fittings for copper tubing?
Flare fittings on the end of copper tubing should provide a strong connection to a fixed point with a threaded nipple. PlumbingSupply.com ® is your source for hard-to-find fittings. And, as always, there is never a minimum purchase requirement. Looking for specialty 3/16″ or 7/16″ sized flare nuts?
Are these flare fittings suitable for natural gas connections?
We prefer flare with soft tubing over 3/8″od in size and compression fittings on all hard copper and soft tubing 3/8″od and smaller. Don’t use compression fittings on gas connections at all as most codes do not allow it nor do we recommend it. Q. “Are these flare fittings suitable for natural gas connections?”
