What causes a Atwood RV gas water heater to not fire up?
One of the most common problems with Atwood RV water heater is a pilot outage. This can happen if you have a weak gas control magnet or if the thermocouple needs to be replaced. For poor pilot flame, you would need to replace the orifice. If it is not too old hen you can try cleaning the orifice and see how it goes.
Why does my pilot light keep going out in my RV?
Usually, a problem with the thermocouple causes the pilot light to go out. The thermocouple is the small copper rod that the pilot light hits. That’s important because gas is always being supplied to the pilot to keep the flame lit. But if the pilot flame goes out, then the gas would still be released.
What to do if pilot light on water heater is not working?
If the pilot line is clogged, clean it or replace it. Faulty piezo igniter. The water heater uses the piezo igniter to light the main gas burner and when it is pressed down, it releases the electric spark.
Why does my Atwood water heater not light?
My Atwood g6a-8e water heater is refusing to light. The green light comes on on the control panel, but nothing happens – the red light doesn’t come on either. Last year I replaced the thermostats, the igniter and the pressure relief valve. The fuse looks good.
How does the pilot light work on a gas heater?
Once there is a need for heating (or call from a thermostat), a gas control valve releases the gas into the main burner, and the pilot light ignites the gas.
What should the pilot flame be on a propane tank?
Important: Before troubleshooting the pilot light, keep in mind that a pilot flame is always ON and the flame should be blue. If it is yellow, it needs an adjustment. Make sure that the tank is completely filled with water before lighting the pilot light.
If the pilot line is clogged, clean it or replace it. Faulty piezo igniter. The water heater uses the piezo igniter to light the main gas burner and when it is pressed down, it releases the electric spark.
My Atwood g6a-8e water heater is refusing to light. The green light comes on on the control panel, but nothing happens – the red light doesn’t come on either. Last year I replaced the thermostats, the igniter and the pressure relief valve. The fuse looks good.
Once there is a need for heating (or call from a thermostat), a gas control valve releases the gas into the main burner, and the pilot light ignites the gas.
Why does my water pilot keep going out?
Therefore, a dirty thermocouple might be the reason why your water pilot keeps going out. A layer of dirt and grime can hinder the electric current from reaching the thermocouple. As a result, the gas supply will be cut off and the pilot light will go out.
