Should the flange be above the tile?
5 Answers. The toilet flange needs to be on top of the finished floor. Meaning the bottom edge of the flange needs to be on the same plane as the toilet. So if your toilet sits on the tile, the flange needs to be on top of the tile too.
How close should tile be to toilet flange?
When you’re tiling around an already-installed toilet, plan out your pattern so that at there is at least 2 in (5.1 cm) of space between the base of the toilet and the edges of any of the tiles you’ll be laying around it.
How high should the toilet flange be above the floor?
With the toilet removed, you can see the toilet flange and measure its height above the floor. The optimum flange height to aim for is 1/4 inch above the finished floor. This typically allows for almost any type of wax ring to be used and still ensure a good seal.
Where to put flooring in an upstairs bathroom?
Cuts are buried against back walls, under cabinets, behind toilets and against bathtubs and showers. If you are happy with the size of the cuts based upon a full tile starting point at the doorway, go with it. Otherwise, you can adjust the layout according to your preferences.
How to install ceramic tile floor in bathroom?
Scrub, screw and patch the floor. 1 Scrub the floor with stripper. Remove the baseboard and toilet. Using an abrasive pad, scrub the floor hard with water mixed with vinyl floor stripper. 2 Drive screws into the floor joists. 3 Cut the door trim to accommodate tile. 4 Fill low spots with thin-set.
Do you fit the toilet before or after tiling the floor?
Should I fit the toilet before or after tiling the floor? The bathroom fitters are unanimous—if you’re looking for a high quality finish, with a better seal against water damage, then always tile the floor first.
How to demo a bathroom from top to bottom?
Cut through any caulk around the toilet base with a utility knife and lift the toilet off the flange bolts. Use your utility knife to scrape away the wax around the drain flange in the floor. Unscrew the flange and remove it. Stuff rags in the drain hole to keep sewer gases from filling the bathroom while you finish your demo work.
How to install ceramic tile flooring in an upstairs bath?
Check the bag of thinset for recommendations based on your size of tile/type of thinset. The extra mud helps cushion the tiles around the area for a flat installation. Keep all of your cuts at least 1/4 inch away from the walls covered by baseboards and 1/8 inch away from any visible terminations, such as against a toilet, shower or tub.
What kind of flooring to use in an upstairs bath?
Ceramic tile flooring is one of the best choices you can make for your upstairs bath. Not only is it one of the most durable flooring materials you can choose from, but it’s also one of the most waterproof.
What do you do with the tub flange?
Pin That pesky tub flange. You have the tile backer board installed and everything is waterproofed. Everything except that gap between the backer board and the tub flange. How do you waterproof that? What to do with the tub flange?
What kind of trowel do you use to install tile floor?
The depth and width of the teeth of your trowel depend on the type and size of the tile. The size of the notch determines how much thin-set is left on the floor under the tile. Typically, the larger the tile, the larger the notch should be. Use your trowel to scoop out a generous amount of mortar from your mix bucket.
