Is my tankless water heater heat exchanger bad?
A tankless water heater can develop leaks inside the heat exchanger. A corroded water heater almost always needs to be replaced. If the tankless water heater doesn’t properly vent out exhaust gases from the heat exchanger, it can cause the heat exchanger to corrode, and this can be potentially harmful to your house.
What kind of water heater does Paloma use?
All Paloma gas water heaters are tankless that can run by using natural or propane gas and provide hot water on demand in an endless supply. They are small and wall-hanging, with an option for indoor or outdoor installation.
What causes pilot flame outage on Paloma water heater?
Twenty-five seconds is normal. Three components are responsible for pilot flame outages: thermocouple (usually lasts 10+ years), magnetic valve (only a problem after it’s disturbed; do not disturb it), or fuse circuit fusible link (usually the part that we replace). Through the process of elimination we will determine which part is at fault.
Is the ph5-3f ph6d water heater working?
PH5-3F, PH6D water heater is working, but a small amount of water is leaking from weep hole left of the diaphragm housing. Replace gas valve body/assembly which is the left side casting of the diaphragm housing and rebuild water valve. See I,A,1. Pressure / Temperature Relief Valve opens after hot water is turned off.
All Paloma gas water heaters are tankless that can run by using natural or propane gas and provide hot water on demand in an endless supply. They are small and wall-hanging, with an option for indoor or outdoor installation.
Twenty-five seconds is normal. Three components are responsible for pilot flame outages: thermocouple (usually lasts 10+ years), magnetic valve (only a problem after it’s disturbed; do not disturb it), or fuse circuit fusible link (usually the part that we replace). Through the process of elimination we will determine which part is at fault.
PH5-3F, PH6D water heater is working, but a small amount of water is leaking from weep hole left of the diaphragm housing. Replace gas valve body/assembly which is the left side casting of the diaphragm housing and rebuild water valve. See I,A,1. Pressure / Temperature Relief Valve opens after hot water is turned off.
