How to fix a whirlpool electric water heater?
Switch the two house circuit breakers dedicated for the water heater to OFF. Remove the control panel and check the electrical connections on the electronic thermostat. If the wiring and connections are okay, replace the lower thermistor sensor located above the lower heating element.
How to override the ESM on a whirlpool water heater?
You can override the ESM by unplugging the harness connector. The water heater electronic thermostat will continue to operate and hot water will still be available. Replace the ESM.
Where is the thermocouple on a whirlpool water heater?
Use an adjustable wrench to loosen the thermocouple from beneath the gas control valve/thermostat by turning it counterclockwise. The thermocouple is a thin copper tube attached to the left of the manifold tube. Use the adjustable wrench to loosen the pilot tube by turning it counterclockwise.
Where is the pilot tube on a whirlpool water heater?
Use the adjustable wrench to loosen the pilot tube by turning it counterclockwise. The pilot tube is a small-diameter tube located to the right of the manifold tube.
How do you remove the thermocouple from a whirlpool water heater?
Remove the manifold burner assembly from the burner chamber by pulling it out and away from the water heater. Remove the two piece wire connector that secures the thermocouple and igniter wire through the manifold door by removing the retainer clip holding it.
How can I repair my Whirlpool electric water heater?
Remove the water heater’s upper access panel. Carefully remove the insulation and plastic cover. Identify the power supply wires. Usually, these connect to the top two screws of the upper thermostat. Turn the circuit breaker back on and check for voltage on the top two screws of the upper thermostat.
When to turn on hot water heater Whirlpool?
A water heater must be completely full of water before electric power is applied or the upper heating element will burn out (this is called Dry Fire). The Installation Instructions require that a hot water faucet be opened and the hot water allowed to run full for at least three minutes before turning the power on.
Use the adjustable wrench to loosen the pilot tube by turning it counterclockwise. The pilot tube is a small-diameter tube located to the right of the manifold tube.
