How to check if your Rinnai v1200 is compatible?
To see if your model is compatible you can call our technical support line on 1300 555 545 option 3. Hi my v1200 has 2 remote pads and irrespective of which one is activated the hot water runs for a few seconds then the temp flashes an 11 or 12 and water remains cold.
Where can I get a Rinnai V1500 water heater?
They can be reached on 1300 555 545. Hello , we have a V1500 unit that works well to the Bathrooms and laundry that are within 6 metres of the water heater. Trying to get hot water to the kitchen sink about 20 metres away has always been a problem in the last 10 yrs.
How does a Rinnai continuous flow water heater work?
Rinnai Continuous Flow water heater products do not use a pilot light� When installed and operated without water controllers, the opening of any hot water tap will automatically start the appliance. Once water is flowing through the appliance the burner will be ignited by electronic ignition.
Do you have to be connected to power to start Rinnai?
Yes Lisa, the unit should be connected to the power, gas and water supply. All 3 must be connected and turned on in order for the unit to start. Thank you for the question. We would suggest checking the water filter as it could be blocked. If the issue continues a service call will be required, you may contact us on 1300 555 545.
What to do if your Rinnai v1200 is not working?
We would recommend checking the gas supply and then try to reset the unit by unplugging at the power point for 3-4 minutes and then plugging back in again and turning on the hot water on/ If these measures do not work you may need to arrange a service call to diagnose the issue with the unit.
They can be reached on 1300 555 545. Hello , we have a V1500 unit that works well to the Bathrooms and laundry that are within 6 metres of the water heater. Trying to get hot water to the kitchen sink about 20 metres away has always been a problem in the last 10 yrs.
Rinnai Continuous Flow water heater products do not use a pilot light� When installed and operated without water controllers, the opening of any hot water tap will automatically start the appliance. Once water is flowing through the appliance the burner will be ignited by electronic ignition.
Yes Lisa, the unit should be connected to the power, gas and water supply. All 3 must be connected and turned on in order for the unit to start. Thank you for the question. We would suggest checking the water filter as it could be blocked. If the issue continues a service call will be required, you may contact us on 1300 555 545.
