How much does an Autotrol water softener cost?
They come with meter heads that allow you to control and set the the softener program that enable high efficiency regeneration that minimizes how much salt you use. Autotrol water softener prices fit in with the general cost of water softeners as prices typically start upwards of $514. This is of course for a lower spec and capacity model.
How long does a Autotrol softener control valve last?
The expected life span of the Autotrol softener control valve is 20 – 30 years with a few minor repairs along the way. The Flapper Valve Discs in the valve body generally need replacement after 15 – 20 years.
What kind of valve does Autotrol 1550-tc use?
Autotrol 1550-TC is just the way many Autotrol Series 155 Timer Housings are labeled ( 440 timers ). And normally the valve is Model 155. This is the same design used for almost 30 years (replaced by the updated 255 Series in late 1996 ).
When to replace flapper valve on Autotrol 155?
However, if your system is on a chlorinated water source, the Flapper Valves ( part # 155A152 ) will need replacement much sooner ( 5 – 10 years is common ). On chlorinated water supplies it is also necessary to replace the Flow Control Ball ( part # 4F ) which sits inside the Backwash Plug on the right rear of your valve.
What kind of motor does Autotrol water softener use?
Autotrol is a vertical manufacturer of things like water softeners.They also produce a wide range of custom AC magnet synchronous geared motors and DC geared motors. The company was founded in 1964. It is well known for its wide range of applications and its knowledge about geared motors.
The expected life span of the Autotrol softener control valve is 20 – 30 years with a few minor repairs along the way. The Flapper Valve Discs in the valve body generally need replacement after 15 – 20 years.
Autotrol 1550-TC is just the way many Autotrol Series 155 Timer Housings are labeled ( 440 timers ). And normally the valve is Model 155. This is the same design used for almost 30 years (replaced by the updated 255 Series in late 1996 ).
However, if your system is on a chlorinated water source, the Flapper Valves ( part # 155A152 ) will need replacement much sooner ( 5 – 10 years is common ). On chlorinated water supplies it is also necessary to replace the Flow Control Ball ( part # 4F ) which sits inside the Backwash Plug on the right rear of your valve.
