How long does it take for water to get hot after pilot light?
The average gas heater takes between 30 and 40 minutes to fully heat up the water in its tank.
How do you check the Pilot on a water heater?
It’s usually right on the panel. Turn and hold the knob to “Pilot” and push the ignitor. You should hear it click, and probably also a “whooshing” sound. Check in that gap, and you should see the light on.
How do you light the pilot light on an AO Smith water heater?
How do you light the pilot light on a AO Smith water heater? Take the access panel off the side of the A.O. Turn the gas control knob on the side of the water heater to the “Off” position, and allow the room to air out for approximately 10 minutes. Set the gas control knob to the ” Pilot ” position.
What to do when your water heater pilot light goes out?
When the pilot light goes out, here’s how to light a gas water heater pilot light: Your first step is obvious: to try to re-light the water heater pilot light. First things first, try to light it again before assuming there is a major problem.
Is it dangerous if the pilot light goes out on the water?
This is how natural gas smells, and once you notice it, you must turn off the gas to the heater. Before taking such a dangerous matter into your own hands, try contacting the gas company, and wait for their instructions.
Why does my water pilot keep going out?
Therefore, a dirty thermocouple might be the reason why your water pilot keeps going out. A layer of dirt and grime can hinder the electric current from reaching the thermocouple. As a result, the gas supply will be cut off and the pilot light will go out.
Why does the pilot light go out on an A.O.Smith water heater?
Occasionally, the pilot light on your A.O. Smith water heater might go out due to an interruption of service or repairs needed on the appliance. A.O. Smith water heaters, including the Conservationist model, use a modern built-in piezoelectric igniter system that allows you to light the pilot by pushing the ignition button.
When the pilot light goes out, here’s how to light a gas water heater pilot light: Your first step is obvious: to try to re-light the water heater pilot light. First things first, try to light it again before assuming there is a major problem.
Where is the pilot light on a gas heater?
The pilot light should be close to the gas burner tube, watch it closely. Ignite the flame with a long match while switching the knob to “pilot,” hold it in the position for 35 seconds. Once the pilot comes on, turn the knob back to “on.”
What does it mean when your pilot light goes out?
The pilot light flame going out means that the burners won’t ignite, and you’ll suffer the wrath of freezing, cold water. So here are a few common reasons which could be the culprits for your pilot light going out.
