How is Honeywell l6006a aquastat controller used in hydronic heating?
APPLICATION The Honeywell SUPER TRADELINEfi L6006A Controller operates in response to temperature changes in hydronic heating systems. It provides spdt switching for high limit, low limit or circulator control. The L6006A is designed for horizontal or vertical insertion/mounting using an immersion well (not included).
What do you need to know about Honeywell l6006?
Page 15: Adjustments L4006,7,8; L6006,7,8 AQUASTAT® CONTROLLERS Low Limit Controller R-B terminals provide low limit switching function (contacts open at set point… Page 16 L4006,7,8; L6006,7,8 AQUASTAT® CONTROLLERS Adjust the control point to correspond with the boiler Table 3.
How does the l6006c SPDT control work?
The L6006C control is a SPDT control R-B is normally closed and opens on a temperature rise. R-W is normallly open and closes on a temperature rise. You only need to break into the 120 volts which is fed to the fan motor with the R terminal and then run the wire from W to the fan motor.
Can you use teminal 3 on a l6006 fan?
If the answer is yes then you can wire the L6006 in series with teminal 3 on relay and the other side of L6006 wire to the Red wire going to the fan. This will give you temperature control on when the fan will come on. When the thermostst is turned up, the fan immediately comes on.
APPLICATION The Honeywell SUPER TRADELINEfi L6006A Controller operates in response to temperature changes in hydronic heating systems. It provides spdt switching for high limit, low limit or circulator control. The L6006A is designed for horizontal or vertical insertion/mounting using an immersion well (not included).
Page 15: Adjustments L4006,7,8; L6006,7,8 AQUASTAT® CONTROLLERS Low Limit Controller R-B terminals provide low limit switching function (contacts open at set point… Page 16 L4006,7,8; L6006,7,8 AQUASTAT® CONTROLLERS Adjust the control point to correspond with the boiler Table 3.
The L6006C control is a SPDT control R-B is normally closed and opens on a temperature rise. R-W is normallly open and closes on a temperature rise. You only need to break into the 120 volts which is fed to the fan motor with the R terminal and then run the wire from W to the fan motor.
If the answer is yes then you can wire the L6006 in series with teminal 3 on relay and the other side of L6006 wire to the Red wire going to the fan. This will give you temperature control on when the fan will come on. When the thermostst is turned up, the fan immediately comes on.
