How do you turn off a Keston boiler?

How do you turn off a Keston boiler?

Set the external controls to OFF. Wait 4 minutes and then isolate the mains supply to the boiler. Set the external controls to OFF. Switch the electricity supply to OFF.

What does L2 mean on a logic Combi 30 boiler?

has lost its flame
The ‘L2’ means your boiler has lost its flame. This can happen for a variety of reasons, including that your gas pressure has dropped too low or that the flue has a blockage. If you have a pay-as-you-go gas meter and accidentally run out of gas, you may see this code displayed on your boiler.

How do you fix a low pressure boiler?

Top tip!

1. Switch off and allow your boiler to cool.
2. Double-check that both ends of the filling loop are securely attached.
3. Open both valves, to allow cold mains water into the system (you should hear it)
4. Wait for the pressure gauge to read 1.5 bar.
5. Close both valves, one after the other.

What do you need to know about the Keston C36 Combi?

The Keston C36 Combi is designed for installation on sealed water systems only. With fully pumped water circulation. The pump, an 8l expansion vessel and associated safety devices are fitted within the boiler.

How do you troubleshoot a Keston combi boiler?

When troubleshooting your Keston Combi boiler please follow the following logical fault finding procedure Electrical Safety Checks. Check the electrical circuits by testing short circuit, earth continuity and resistance to earth tests. Check correct electrical polarity. Electrical Supply.

Is the C36 Combi a cast iron boiler?

The C36 Combi is not a high water content boiler and does not contain the metal mass, or water volume, of a cast iron or steel boiler. This boiler is of low mass and low water content and therefore responds faster when there is a call for heat.

How do you start a combi C30 boiler?

Start the boiler as follows: 1. Set the mode knob (C) to ‘BOILER OFF’. 2. Set the Domestic Hot Water temperature knob (A) and Central Heating temperature knob (B) to ‘MAX’. 3. Ensure that all hot water taps are turned off. 5. Switch on electricity to the boiler and check that all external controls, e.g. programmer and room thermostat, are on. 4.

The Keston C36 Combi is designed for installation on sealed water systems only. With fully pumped water circulation. The pump, an 8l expansion vessel and associated safety devices are fitted within the boiler.

When troubleshooting your Keston Combi boiler please follow the following logical fault finding procedure Electrical Safety Checks. Check the electrical circuits by testing short circuit, earth continuity and resistance to earth tests. Check correct electrical polarity. Electrical Supply.

The C36 Combi is not a high water content boiler and does not contain the metal mass, or water volume, of a cast iron or steel boiler. This boiler is of low mass and low water content and therefore responds faster when there is a call for heat.

Start the boiler as follows: 1. Set the mode knob (C) to ‘BOILER OFF’. 2. Set the Domestic Hot Water temperature knob (A) and Central Heating temperature knob (B) to ‘MAX’. 3. Ensure that all hot water taps are turned off. 5. Switch on electricity to the boiler and check that all external controls, e.g. programmer and room thermostat, are on. 4.