How do you reset Navien error codes?

How do you reset Navien error codes?

Navien NPE Error Code E016

1. Turn OFF the unit, wait at least 30 min, and then restart.
2. Clean the inlet water filter and strainer.
3. Check the heat exchanger and flush it if required.
4. For your safety and the health of your equipment, Call or Contact Hot Water Now!
5. Check the high limit switch and PCB.

Where can I get a Paloma tankless water heater repaired?

Our tankless experts are here to help. Low Energy Systems has a full-service center to repair or rebuild your Paloma/WaiWela tankless water heater. We are Paloma’s largest distributor and certified service and repair experts and stock parts for all Paloma/WaiWela Water Heaters.

What causes a Paloma water heater to go out?

Three components are responsible for pilot flame outages: thermocouple (usually lasts 10+ years), magnetic valve (only a problem after it’s disturbed; do not disturb it), or fuse circuit fusible link (usually the part that we replace). Through the process of elimination we will determine which part is at fault. 4.

What’s the serial number on a Paloma water heater?

Specify model and serial number when placing order. PH12,16,24 water heater is working but a small amount of water is leaking from 1/8″ diameter hole directly above top of water control case assembly (part #110). Purchase water valve rebuild kit and replace O-ring part #108.

Are there any legacy tankless water heaters left?

Have a Legacy Model (PH-5, PH-6, PH-12, PH-16, PH-24)? Although no longer manufactured, Paloma Legacy Tankless Water Heaters are very popular and are installed in several boats, RVs, Laundromats, restaurants and hotels.

How to troubleshoot a Paloma tankless water heater?

Turn the hot water faucet on and open it to full capacity. The tankless unit should start up again when you turn on the hot water faucet. Refer to your instruction manual if the error code is still displayed. Refer to your manual if the error code remains displayed.

Specify model and serial number when placing order. PH12,16,24 water heater is working but a small amount of water is leaking from 1/8″ diameter hole directly above top of water control case assembly (part #110). Purchase water valve rebuild kit and replace O-ring part #108.

What causes pilot flame outage on Paloma water heater?

Twenty-five seconds is normal. Three components are responsible for pilot flame outages: thermocouple (usually lasts 10+ years), magnetic valve (only a problem after it’s disturbed; do not disturb it), or fuse circuit fusible link (usually the part that we replace). Through the process of elimination we will determine which part is at fault.

What makes a Paloma water heater turn yellow?

1. Observe pilot light with front cover removed. Any yellow indicates a plugged pilot air filter. A yellow flame is weak, tentative, lazily drifting, without continuous bearing on thermocouple tip. Solution: Take a deep breath and blow out the obstructed pilot air filter or use compressed air.