How do you reset a state select gas water heater?

Locate the large red button marked “Reset” at the center of your State water heater’s control circuit panel. Firmly press the “Reset” button to manually reset your water heater. Once your water heater has been reset, it may take between 12 and 24 hours for your water heater to resume normal operation.

Are water heater gas valves interchangeable?

Natural and propane water heater gas valves are not interchangeable, so, be sure to order a valve for your type of gas.

What to do if your water heater won’t stay lit?

Thermostatic Control or Gas Valve If your gas water heater doesn’t stay lit, you may have a defective control thermostat. This control is part of the gas valve assembly and normally has a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature.

When does the pilot light go out on a water heater?

Discussion in ‘ Water Heater Forum, Tanks ‘ started by jeremytl, Aug 20, 2012 . I replaced the thermocouple. It’s installed correctly. I get a nice blue flame. No drafts. No water dripping on pilot light. When I go to light pilot light, I hold down the knob for 60 seconds, as soon as I let up on the knob the pilot goes out.

How much does it cost to replace the pilot on a gas water heater?

Find the manual, it says replace the whole pilot assembly which is $77 for the part not 10 bucks for a hardware store thermocouple. It is a State Select High Efficiency WH. Damn. Can’t get one on Saturday but can order it.