How do you reset a AO Smith gas water heater?
How do I reset my water heater? Part 2 Pressing the Reset Button Locate the red reset button. There should be a red button in the center of the control panel. Press the button firmly.
How do you light the pilot light on an AO Smith water heater?
How do you light the pilot light on a AO Smith water heater? Take the access panel off the side of the A.O. Turn the gas control knob on the side of the water heater to the “Off” position, and allow the room to air out for approximately 10 minutes. Set the gas control knob to the ” Pilot ” position.
How to igniter pilot light on gas water heater?
You will usually turn the dial to pilot and hold down the button. Then press the igniter until the pilot lights. Hold the button down for as long as it tells you. See the article ‘ Following Pilot Light Lighting Instructions ‘ for information on how to locate the instructions and why it is important to follow them.
Why is my AO Smith water heater turning off?
Your unit turned off because on the t couple there is a thermal sensor. When the unit overheats due to air starvation it will trip and turn off all gas.. When the unit starves for air you get draft issues and CO leaks out the top of the flue into your home..
How old is A.O.Smith hot water system?
A.O. Smith supports you with a wide range of parts and accessories and has over 40 years of experience in providing reliable hot water solutions. We also provide information on all the parts of our various devices with drawings in which all parts are clearly shown.
How do you light the pilot light on a AO Smith water heater? Take the access panel off the side of the A.O. Turn the gas control knob on the side of the water heater to the “Off” position, and allow the room to air out for approximately 10 minutes. Set the gas control knob to the ” Pilot ” position.
What kind of ignitor for AO Smith water heater?
Water Heater Nitride Ignitor and Flame Sensor Assembly for AO Smith part number 9003626005. 5 Connection Molex Plug. Metal mounting Bracket. Batteries Required?
You will usually turn the dial to pilot and hold down the button. Then press the igniter until the pilot lights. Hold the button down for as long as it tells you. See the article ‘ Following Pilot Light Lighting Instructions ‘ for information on how to locate the instructions and why it is important to follow them.
What causes gas valve to fault out on AO Smith water heater?
Original part caused gas valve to fault out on weak flame and igniter codes for years. I’d clean the senor but did not have too much luck. While trying to clean sensor for 3rd time I broke the igniter. OEM assembly was a White-Rodgers part and was kind of pricey to put into a 16 year old tank.
