How do you replace an old jet pump?
Unscrew the wires going to the pressure switch on the old jet pump with a screwdriver. Remove the old pump. Apply Teflon piping tape on the threads of the outlet and inlet pipes, wrapping tape around each pipe at least 5 times to get a proper seal.
How big of a drop pipe do you need for a hand pump?
The bottom of the pump has 1-1/4″ fips threads. For optimum water flow the drop piping used should not be smaller than 1-1/4″ pipe. 1″ piping can be used but will decrease the amount of water volume pumped out through the spout. Your drop pipe should be at least 5 feet longer than the actual water pumping level.
How do you replace a drop pipe in a well?
If you have a well seal or Morrison head, undo the connection between the drop pipe and outlet line that is above ground. On a well seal, use a wrench or ratchet to loosen the bolts on the seal. After you do this, pull the drop pipe up through the seal a foot or so, and attach a pipe dog, using the guidelines below to properly set the tightness.
How do you remove a pipe from a pump?
Disconnect the pipe from the pressure tank or pump. For a submersible pump, the point of connection with the surface plumbing will be the pressure tank. The plumbing will connect directly to the pump on any surface pump. Tighten two pipe wrenches on the top of the pipe and lift.
Unscrew the wires going to the pressure switch on the old jet pump with a screwdriver. Remove the old pump. Apply Teflon piping tape on the threads of the outlet and inlet pipes, wrapping tape around each pipe at least 5 times to get a proper seal.
If you have a well seal or Morrison head, undo the connection between the drop pipe and outlet line that is above ground. On a well seal, use a wrench or ratchet to loosen the bolts on the seal. After you do this, pull the drop pipe up through the seal a foot or so, and attach a pipe dog, using the guidelines below to properly set the tightness.
What to do if your submersible pump is jamming?
Drop pipe jamming submersible pump check valve. Raise pump to inspect drop pipe connection to pump outlet. Threaded area of drop pipe may be screwed in too far, jamming the check valve in a closed position. Loosen the drop pipe and cut off a portion of the threads.
What do you do when you replace a well pump?
Turn on a hose or faucet to release all the pressure from holding tanks or pressure tanks by letting the water drain out. When you install a new pump, you need to drain the water from the pumping system. Use a plumber’s wrench to take off the inlet and outlet ports on the old well pump.
