How do you replace a bathtub faucet stem?
Install the stem bonnet by placing it into the pipe fixture. Turn the stem bonnet to the left with the tub socket wrench to remove it. Then install the cartridge into the stem. Secure it with new retainer clips and slide the new handles over the cartridge stem piece. Insert the handle mounting screws.
When to replace trim on bath tub faucet?
Trim pieces are sometimes replaced when you replace a bath tub faucet or install a new one. This is a simple step, just loosen the trim screws and remove the plate before you install the stem bonnet.
How do you turn off a bath tub faucet?
Turn off the water to your bath tub faucet by turning the water shut off valve to the “off” position. Take out the older bath tub faucet handle (or handles if it has a double handle design). In order to do this you have to pry off the cap on the handle and loosen the small, Allen screw right below it.
How to unscrew faucet valve stem when it’s stuck?
Screw on a pipe coupling and a 2 foot pipe nipple to the side outlet. Put the top hex nut in a vise. Use the pipe nipple and unscrew the valve body and valve stem. I had a Jado 1/2 inch cold cartridge. I had to disconnect the braided water lines and backed the entire valve down below the granite counter.
Install the stem bonnet by placing it into the pipe fixture. Turn the stem bonnet to the left with the tub socket wrench to remove it. Then install the cartridge into the stem. Secure it with new retainer clips and slide the new handles over the cartridge stem piece. Insert the handle mounting screws.
How to remove hot and cold tub valve stems?
Turn on the hot and cold water in the tub to release residual pressure in the lines. Place a towel in the tub over the drain hole to prevent lost parts. Pry the “Hot” and “Cold” caps or screw covers off of the valve handles using your fingernail.
How does a tub faucet diverter stem work?
How to Replace a Tub Faucet Diverter Stem. A tub faucet diverter is a small flap behind your bath tube facet handle that determines whether water will flow out of the shower or out of the tub faucet. In a single-handle faucet, you will likely have to push or pull the shower faucet handle to divert water.
How do you change the cartridge in a bathtub?
Bathtub cartridges regulate water flow and temperature. To change a bathtub cartridge, begin by removing the handle as described in Step 1. Remove the screws holding the escutcheon plate in place and slide out the escutcheon. Remove the retaining clip that holds the cartridge in place with a screwdriver. Remove the cartridge with pliers.
