How do you remove the side panel on a Jacuzzi tub?
Turn off the jets and drain the tub of all water. Turn off the main breaker of your electrical box to ensure that no power is going to the tub before performing any repair. Place a large suction cup firmly against the front access panel, put your finger inside the attached ring and pull toward you to remove the panel.
How do you remove a bath panel?
Pull the left hand side out at the bottom as that’s the free end, you’ll need to twist the panel to pop the tongue at the top out from under the bath, then slide the whole panel out by pulling it in the left hand direction and outwards.
Do you need access panel for whirlpool tub?
A whirlpool tub has a motor that will need to be accessed for repairs and replacement. So it’s important to include an access panel into your planning for installation.
Where can I find the model number of my Kohler Bath?
The purchase invoice will list the model number of your bath product. Depending on the bath style, the front cover of the installation guide may include the model number. If the purchase invoice or installation guide is not available, contact the Customer Care Center at 1-800-4KOHLER for assistance.
How does the Whirlpool work on a Kohler Bath?
The air actuator: turns the whirlpool on and off through the activation of a sensing device. The 3/4-HP pump motor: provides the power to move the water and create the soothing whirlpool action. The multi-directional jets: provide soothing hydro-massage action to optimize your whirlpool experience.
Where can I find the correct Kohler part?
Find the correct Kohler Genuine Part by entering your Kohler product number or name. Tip: Did you purchase your product on Kohler.com? Great! Check Order History to find your product number.
Can a tub be repaired without an access panel?
The task of gaining access depends on which mechanical part of the system failed and the tub’s location inside or outside of the home. Some repairs may be made without an access panel, but if you need to get to the pump or plumbing you will need access from below the tub or its surrounding sides.
What makes a jetted bathtub need repair?
A jetted bathtub has two main system components: plumbing and pumping. Either or both may fail and require repair. The task of gaining access depends on which mechanical part of the system failed and the tub’s location inside or outside of the home.
The air actuator: turns the whirlpool on and off through the activation of a sensing device. The 3/4-HP pump motor: provides the power to move the water and create the soothing whirlpool action. The multi-directional jets: provide soothing hydro-massage action to optimize your whirlpool experience.
Can you replace a Roman tub faucet without an access panel?
Changing out your Roman tub faucet is much simpler than you think, even without an access panel. By loosening the set screws, you can lift off the old fixtures and replace them with new ones. You don’t even have to change any valves or mess around with any plumbing pipes.
