How do you relight a pilot light on a water heater?
Relight the pilot light. Turn the control valve to “on”. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks. Note: When relit, the water heater pilot light flame should wrap around the thermocouple bulb.
Why does my water heater pilot light keep going out?
Make sure to follow the directions on your water heater label. If your pilot doesn’t re-light, won’t stay lit or keeps going out after a short time, you most likely have an issue with the hot water heater thermocouple. This can happen with age.
Who is the best person to relight a water heater?
Better yet, a plumber in West Covina, who is very knowledgeable about water heaters and licensed to maintain and fix them, is the best person to have relight the pilot as well as checking to see why the pilot went out in the first place.
What should I do if my gas heater pilot goes out?
This can be very dangerous if the pilot has been out for hours, and the gas has been leaking the whole time. Always check for a gas leak before the pilot is ever relit. Checking for a gas leak is easy enough, just sniff around to see if you detect a bad smell that smells like eggs rotting.
How does a pilot light go out on a water heater?
Some of the most common reasons that water heater pilot lights go out include: A faulty thermocouple. Your thermocouple is responsible for sensing when your pilot light is lit. If it senses that the pilot light has gone out, the thermocouple shuts off the gas supply to the flame in order…
How do I check the pilot light on my water heater?
Open the door/cover over the pilot light access. This will be located under the gas valve; some water heaters just have an open gap instead where you can see the pilot light burner. Use a flashlight or a headlamp to find the burner inside. Two small gas tubes will lead to it.
Why is the water heater pilot light keeps going out?
There are several things that can cause your gas water heater pilot light to keep going out. One of the most common is your thermocouple. If you are unfamiliar with what this device does, the thermocouple is a device in your hot water heater that uses an electrical current to determine whether the pilot light is on or not.
How do you light the water heater pilot?
Turn the gas knob to “Pilot,” press and hold it down. This will start the flow of gas so you can light the flame. Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold.
