How do you move an existing toilet drain?

How do you move an existing toilet drain?

Instructions

1. Remove the Toilet. Remove the toilet from its current location.
2. Gain Access.
3. Remove the Toilet Flange.
4. Cut the Toilet Bend.
5. Position New Drain Location.
6. Run the New Drain.
7. Install the Drain Stub-Out.
8. Run the Water Supply Lines.

Can a toilet drain be moved?

Moving a toilet is not a straightforward weekend DIY job, but it is very doable when you involve the professionals. Once the toilet itself is removed, your plumber will have to move the drainage, as well as the water supply to accommodate the new location.

How do you move a toilet without moving drain?

There is usually a vertical waste water pipe under the toilet that uses gravity to move wastewater away. For the waste water line, an offset toilet flange will allow you to move the toilet a couple of inches in any direction without having to cut a new hole in the floor or reconstruct the waste water pipe.

How much does it cost to move a plumbing stack?

1. Cost of Moving Plumbing Fixtures. The cost to move a toilet or sinks can be $2,500-$3,500 per fixture. Plumbing can be a significant cost factor in a remodel when a bathroom floor plan is altered.

How does a rear outlet toilet work in a bathroom?

A rear outlet toilet is mounted to the floor using two bolts on holes drilled through the bathroom floor. It does not have a flange or wax ring. Some rear outlets toilets are however installed using the same hardware as a standard floor outlet toilet.

What do I need to do to change the location of my toilet?

Moving your Toilet Waste Flange. The first thing you need to do is remove your toilet. Turn off the water supply line to the toilet and flush the toilet empty.

How do you fix a toilet that is not connected to the drain?

Turning the toilet so it angles further from any surfaces is a potential solution. Because the toilet is connected to the drain through a flange, you must rotate the flange to reposition the toilet.

What to put on floor after replacing toilet flange?

Once you lift the toilet off the flange, you’ll usually find that flange replacement is a manageable DIY project; however, you may decide it’s best to call a plumber in some circumstances. Place newspapers or towels on the floor next to the toilet. You will place the toilet on these after you disconnect it from the flange.

A rear outlet toilet is mounted to the floor using two bolts on holes drilled through the bathroom floor. It does not have a flange or wax ring. Some rear outlets toilets are however installed using the same hardware as a standard floor outlet toilet.

What’s the best way to replace the base of a toilet?

To lift it alone, straddle the bowl, bend your knees, grip the underside of the toilet between the bowl and tank, and lift straight up with your legs (not your back). You need to lift the toilet straight up to clear the 2 bolts that are sticking up through the base. Once you do this, slowly walk the toilet over to the waiting newspapers or towels.

How do you replace the float system on a toilet?

To replace the float system, drain the tank the same way as when changing the flapper valve. Once the tank is empty, you will find a large nut at the base of the float system. Loosen that nut and remove the entire float system. TIP: Mark suggests, “Have a small bucket or a rag on the floor beneath where the float system is being removed.

How do you replace the bolts on a toilet bowl?

Replace the washers and nuts on each toilet bowl bolt and evenly tighten the nuts onto the bolts. Be careful not to over-tighten the nuts as it may crack the porcelain bowl. Replace the bolt caps. Replace the toilet tank atop the bowl and align the shank of the bolts with the holes in the bowl.