How do you light a gas water heater after a flood?
Turn the gas supply back on, turn the dial on the gas valve to the “pilot” position and depress the push-button pilot button as you light the pilot under the burner with the log lighter. Hold the pilot button down to “prime” the thermocouple—otherwise it will cut the gas supply to the pilot light.
What do you do if your pilot light won t light?
How to Fix Your Pilot Light
- Find your gas valve.
- You need to turn the valve to the off position for at least three minutes.
- Once you have had the valve at off for a few minutes, switch it over to pilot setting.
- You will need a match that is lit.
- Set the pilot valve to the on position.
What would cause a pilot light to keep going out on a water heater?
The most common reason that your pilot light on your water heater keeps going out is a damaged, bent or dirty thermocouple.
How to troubleshoot pilot light in gas water heater?
When troubleshooting lighting problems, it is recommended to test it first. Turn the gas OFF to the water heater and press the piezo igniter. Once pressed, the electrode should release the spark. Check if the wire connection is tightened correctly. Make sure the electrode is not broken, and replace it if it is.
Is it safe to use a gas water heater after a flood?
The water heater is most likely safe to use as long as the water is not dripping on any components. If you are concerned about safety, consider getting a plumber to do an inspection.
What to do when your gas water heater goes out?
Usually a good teflon tape sealant does the trick. Light the pilot according to manufacturer instructions. The gas water heater should be ready to go. What’s wrong if the pilot light will light, but when I turn on the heater it goes out? Most likely it is due to a bad thermocouple, you’ll need to replace it.
What should the pilot flame be on a propane tank?
Important: Before troubleshooting the pilot light, keep in mind that a pilot flame is always ON and the flame should be blue. If it is yellow, it needs an adjustment. Make sure that the tank is completely filled with water before lighting the pilot light.
When troubleshooting lighting problems, it is recommended to test it first. Turn the gas OFF to the water heater and press the piezo igniter. Once pressed, the electrode should release the spark. Check if the wire connection is tightened correctly. Make sure the electrode is not broken, and replace it if it is.
Can a gas water heater be relighted after a flood?
Check several parts before relighting water heaters after a flood. Most property owners attempt to save as much as they can after a flood. Appliances with complex electronics generally must be replaced, but simpler ones such as gas water heaters might be salvageable.
Usually a good teflon tape sealant does the trick. Light the pilot according to manufacturer instructions. The gas water heater should be ready to go. What’s wrong if the pilot light will light, but when I turn on the heater it goes out? Most likely it is due to a bad thermocouple, you’ll need to replace it.
Important: Before troubleshooting the pilot light, keep in mind that a pilot flame is always ON and the flame should be blue. If it is yellow, it needs an adjustment. Make sure that the tank is completely filled with water before lighting the pilot light.
