How do you flush a motion sensor on a toilet?
I found that if you drape a length of toilet paper over the sensor (folded over a few times), you can fool the Potty Eye. Then when he’s all set we can pull it off and let the flush happen. No more worrying about getting sucked down the pipes and he gets a kick out of fooling the potty!
Why does my Kohler touchless flush toilet Beep?
NOTE: The Touchless Module beeps five times before it activates, indicating low batteries. Batteries are low. Replace the batteries. Do not use rechargeable batteries. Possible Cause: When refilling, the water rises too rapidly and activates the sensor.
What should water level be on Kohler touchless flush toilet?
Raise the bracket on the Touchless Module up one notch (one number lower) on the bracket. Refer to the installation instructions. Verify that the waterline in the tank is not too high. There should be a minimum of 1/2″ (13 mm) between the water and the bottom of the Touchless Module. Lower the water level if needed.
What to do if your Kohler toilet stops refilling?
If you have a KOHLER toilet with a canister valve, check the color of the canister cap. If you have a black cap (such as retrofitted Wellworth® or Highline®), replace it with the cap in canister repair kit K-GP1229656. Partially close the water supply stop to slow the refill rate, which will reduce splashing. Order chain assembly K-1219268.
Why does my Kohler toilet keep splashing water?
Possible Cause: Water is splashing or dripping on the Touchless Module. Make sure the refill hose is inserted as far as possible into the flush valve. Reposition the hose to minimize splashing. If you have a KOHLER toilet with a canister valve, check the color of the canister cap.
How long does a Kohler touchless toilet last?
This little black module is filled with patented cutting-edge technology: a sensor, a circuit board, a flush actuating wheel and the four AA batteries it takes to power your flush. Touchless toilets run on four AA batteries that should last about 6-12 months depending on usage.
NOTE: The Touchless Module beeps five times before it activates, indicating low batteries. Batteries are low. Replace the batteries. Do not use rechargeable batteries. Possible Cause: When refilling, the water rises too rapidly and activates the sensor.
Where is the bracket on a Kohler touchless toilet?
Determine the bracket location and attach it to the tank. Next, hang the module inside the tank with the flush wheel directly above the center of the flapper or one inch to the side of the canister. Connect the flush valve or flapper to the touchless module with the chain.
How does the Kohler touchless flush kit work?
Touchless flushing lets you remove one of the dirtiest things in your bathroom—your toilet’s trip lever. If you choose to remove the trip lever from your toilet, the Touchless flush kit includes a hole cover. Filling this hole gives your toilet a smooth surface that’s easy to wipe clean.
